Dinan's D210-2031 is a 20mm wheel spacer set, sold as two pieces, for 5x112 hubs and a 66.5mm center bore. The manufacturer describes its spacers as CNC-machined aluminum with a weight saving design and an anodized black finish. Spacers move the wheel outward from the hub, which the manufacturer says gives your wheels the desired offset needed to create the stance or look you desire, or clearance necessary to clear brake calipers. At 20mm, this is the thick end of Dinan's 2mm to 20mm range, and the manufacturer says its spacers were developed specifically for Dinan's BMW wheel fitments to eliminate balance problems associated with "universal wheel spacers".
Fitment is the main thing to verify before buying. The manufacturer's application guide lists G chassis 5x112 with M14x1.25 lug bolts, and it notes that some common examples include, but may not be limited to, the F9x M5/M8 & F48/F39 X1/X2's which utilize the G chassis spacer fitment of 5x112 w/ M14x1.25 bolts. Longer bolts are required and sold separately, so budget for an extended-length stud or bolt set in the correct thread. Owners on user forums discuss the G-chassis release, which covers 2019-2021 G20 330i(& xDrive) and related G20, G22, and G30 variants. For install, the manufacturer's older kit sheets advise that whenever the wheels are removed, care must be taken to assure that the front and rear lug bolts are not mixed up!
The manufacturer's general application guide lists M14x1.25 lug bolts for G-chassis 5x112 applications. The manufacturer also notes that certain models use that same G-chassis setup, so confirm your exact model against the guide before ordering.
Yes. The manufacturer states that longer bolts are required when using wheel spacers, and they are sold separately from the spacer set.
Owners on user forums cite the G-chassis release as covering 2019-2021 G20 330i and M340i models, a 2021 G22 M440i, and 2017-2020 G30 530i models, including xDrive variants. Confirm fitment with the manufacturer for your specific vehicle.
This is a moderate DIY job that requires a jack and jack stands, a socket set, and a torque wrench. Per the manufacturer's install sheets for other Dinan spacer kits, you should use secure jack stands rather than a jack alone, and torque lug nuts to 75-80 ft-lbs, though you should confirm the torque value for this specific kit. Remove the wheel, seat the spacer on the hub, and fit the longer studs or bolts in the correct thread. Keep track of front and rear bolts, since they can differ. After installation, check clearance between the tire and rim and nearby components, such as the strut tube, because the manufacturer's sheets call for a minimum gap of about 1/8 inch on at least one kit.