The aFe CONTROL 610-502001-B is a 12.5mm billet spacer for 5x120 BMW hubs, made for drivers who want their wheels pushed outward to fill the fender gap. Each spacer is CNC-machined from 6061-T6 aluminum with a black anodized finish, and it is sold as a pair. Its hub-centric body locates the wheel on the hub bore, so the lug nuts are not the only thing holding the wheel centered. That matters because owners on user forums commonly trace spacer vibration to lug-centric designs. Pry pockets cut into the body make removal easier after corrosion or heat has bonded the spacer to the hub.
Choose this set over a generic universal spacer when hub fit matters more than a bargain price. The manufacturer's install sheet covers BMW E and F series models, but fitment details vary across published lists, so confirm your model, year, and hub height before ordering. Because the spacer adds thickness, you will need longer wheel studs or bolts, which are not included. The manufacturer's install sheet references a 27mm OEM BMW lug bolt length and gives thread-engagement guidance for common stud sizes. No CARB EO number is required for this part. Search terms such as "BMW 5x120 12.5mm hub centric spacers," "72.6 hub bore wheel spacer," and "E90 spacer install" match this product's application.
Yes. The manufacturer states that longer wheel bolts or studs are required and are not included. Its install sheet lists the OEM BMW lug bolt length as 27mm and recommends enough thread engagement for the stud size.
The manufacturer describes a hub-centric design that centers the wheel on the hub, which it says transfers wheel loads to the hub and reduces vibration.
The manufacturer added pry pockets so the spacer can be pried off without damaging the hub or spacer. Owners on user forums report that spacers can seize over time, so cleaning the hub mating surface during install helps.
This is a bolt-on job for a home mechanic with a floor jack, stands, and a torque wrench. Per the manufacturer's install sheet, raise the vehicle at the factory jack points, remove the wheels, and clean the hub and wheel mating surfaces. Place the spacer on the hub and confirm its maximum allowable hub height is equal to or greater than the car's hub height. A plastic hub cap can be removed to gain a few millimeters of clearance. Align the mounting holes, reinstall the wheel, snug the lugs, spin the wheel to check for interference, and then torque the lugs in a star pattern to factory specification. Owners on user forums commonly recommend rechecking torque after the first 50 to 100 miles and wire-brushing the hub to prevent seizing. Torque figures reported by owners vary by model, so confirm the factory spec for your car.