The aFe CONTROL 610-721003-B is an 18mm billet aluminum wheel spacer for the Toyota GR Supra and BMW G-Series, which the manufacturer lists on its site under a 5x112 bolt pattern with a 66.6mm center bore. The manufacturer describes the CONTROL line as hub-centric, so the spacer centers the wheel on the hub instead of relying on the lug nuts alone, which aFe says eliminates vibration. Machined pry pockets let you safely remove a spacer that has seized to the hub from corrosion, debris, or heat cycles, a common problem with spacers that have been on a car for years. Compared with a cheap non-hub-centric spacer, the 18mm thickness moves the wheel outward to change offset and fill the fender without modifying the wheel itself, and aFe frames the result as added brake and suspension clearance along with a wider track. Search terms: 5x112 18mm hub-centric spacers, GR Supra wheel spacer 66.6, BMW G-series billet spacer, G30 5-Series wheel spacer.
Because the spacer pushes the wheel away from the hub, the manufacturer states that longer wheel bolts or studs are required, and they are not included. Confirm the correct stud diameter and thread pitch in your owner's manual before ordering hardware, and make sure the bolts seat with full thread engagement. Owners on user forums recommend a calibrated torque wrench, no impact tools for final torque, and a retorque after the first drive. The manufacturer also advises sourcing a tire shop for mounting and balancing. If you run a different wheel offset or a heavier tire, verify clearance before driving, since fitment depends on your specific wheel and tire combination.
Yes. The manufacturer states that this spacer requires longer wheel bolts or studs, which are not included, and advises checking the owner's manual for the correct diameter and thread pitch.
The manufacturer notes that spacers can stick to the factory hub due to corrosion, debris, and heat buildup. The pry pockets give you a safe place to pry the spacer off without damaging the hub or the spacer.
The manufacturer describes the CONTROL spacer as hub-centric, meaning the wheel is centered by the hub so wheel loads transfer to the hub rather than only through the lug studs.
This is a moderate-difficulty job that fits a home garage with basic equipment: a floor jack, jack stands, a torque wrench, and a socket set sized for your lug nuts. Remove the wheel, clean the hub face and the spacer bore so the spacer sits flat and fully hub-centric, then install the spacer with the longer bolts or studs you have sourced. Owners on user forums commonly add a light coat of anti-seize on the hub face to ease future removal, and recommend a thread locker on the spacer fasteners. Torque to the vehicle's factory specification in a star pattern, avoid impact tools for final torque, and recheck torque after the first 50 to 100 miles. Have the tires mounted and balanced by a shop, and confirm clearance at full steering lock before driving.