The H&R 1456502SW is a black M14 x 1.5 extended wheel bolt with a 65 mm shank, an R14 Mercedes ball seat, and a 17 mm hex head. Its main job is clamping a wheel through a spacer, so the extra length is the reason to buy it instead of a stock bolt. Owners on user forums report that stock R14 bolts on the W204 C-Class measure roughly 27 to 28 mm, so 65 mm only makes sense when your spacer stack-up requires that reach. Matching the R14 seat matters because a cone-seat bolt on a ball-seat wheel loses clamping contact. H&R-branded hardware with the correct seat is a more predictable choice than a generic extended bolt for a Mercedes ball-seat wheel.
Clean the hub and wheel mating faces, run each bolt down by hand, and tighten in a star pattern with a torque wrench to your vehicle or wheel manufacturer's specification rather than an impact gun. Confirm the thread fully engages without bottoming out, and that the shank does not contact anything behind the hub. Searches for H&R 1456502SW, M14x1.5 65mm R14 ball seat bolt, Mercedes spacer extended lug bolt, and 17mm hex black wheel bolt all point to this exact application.
The manufacturer lists it with an R14 Mercedes ball seat. The seat must match the wheel, because ball and cone seats are not interchangeable and the wrong seat can prevent proper clamping.
The manufacturer lists the 1456502SW as a single bolt and also offers a 1456502SW SET in a box of ten, which covers a full set of wheels.
Owners on user forums report that stock R14 bolts on the W204 are about 27 to 28 mm long, and extended bolts are used when wheel spacers are fitted. Confirm the length you need against your spacer thickness before ordering.
This is a moderate-difficulty DIY job that needs a 17 mm socket or wrench, a torque wrench, and a jack and stands rated for the vehicle. Remove the old bolts, clean the hub and wheel contact surfaces, and fit the spacer and wheel before running the new bolts in by hand. Tighten in a star pattern to the vehicle or wheel manufacturer's torque specification, and recheck torque after the first short drive. Watch for two common mistakes: a bolt that bottoms out before the thread is fully engaged, and a shank long enough to contact brake or ABS components behind the hub.