The H&R 1456006SW is an extended 14 x 1.5 Porsche-style lug bolt, 60mm long with a 19mm hex head and a black finish, for when a wheel spacer or a different wheel needs more shank length than factory hardware. The manufacturer lists it with a Porsche ball seat (R14), and it is also sold in sets of 10. Owners on user forums say the H&R ball seat matches OEM and fits Porsche factory wheels well. Budget lug bolts often skip the thicker swivel washer on factory hardware, so this bolt is the better choice for a spacer setup that needs to keep the stock look and seating.
Use this bolt for spacer work on Porsche chassis such as the 996 and 997, where the length must match the spacer. The manufacturer's rule is that replacement bolts must be longer than the originals by the thickness of the spacer, and the head must match the existing bolt. Owners on user forums report using 60mm bolts with 15mm spacers on 996 cars, which works out to a 45mm factory bolt plus the spacer. For M14 x 1.50 hardware, the manufacturer specifies at least 7.5 turns of thread, about 12mm of load-bearing shaft, and that minimum is what a DIY installer should check before driving.
The manufacturer states that new bolts must be longer than the originals by the width of the spacer, with the head matching the existing bolt. Owners on user forums have paired 60mm bolts with 15mm spacers on 996 chassis. Confirm the seat type and length for your spacer before ordering.
The manufacturer specifies at least 7.5 turns for M14 x 1.50 bolts, which is about 12mm of load-bearing shaft length.
The manufacturer lists the 1456006SW as a single bolt and also offers a SET option in a box of 10.
This is a straightforward bolt swap that needs a 19mm hex socket or wrench and a torque wrench for the final tightening. Measure your spacer thickness first so the bolt length is right. Before driving, turn the wheel by hand and check for rubbing on the inside of the hub, and make sure the bolt does not contact ABS sensors or brake components. Owners on user forums warn that an overlong bolt can intrude into the rear parking brake area, so check clearance there too. Torque the bolts to your vehicle and wheel maker's specification.