The H&R 1455501 is a single M14x1.5 wheel bolt with a 55mm shank, a 60-degree tapered (cone) seat, and a 17mm hex head, finished in silver. H&R lists it among its wheel bolts in the 14x1.5 family, which makes it a practical choice when a wheel spacer or aftermarket wheel needs a longer fastener than stock. The cone seat has to meet the wheel's bolt hole squarely, and that contact is what keeps the wheel clamped under the hard cornering and braking loads that track-focused drivers put on their hubs. Compared with an unbranded bolt of similar length, a bolt from a manufacturer that publishes exact seat, thread, and length data gives you a verifiable match rather than a guess.
Fitment comes down to three things: the 14x1.5 hub thread, the 60-degree seat, and the shank length relative to your wheel and hub. Owners on user forums report that bolt-on spacers generally call for longer bolts than stock, so measure the spacer thickness and confirm the remaining thread engagement before ordering. For installation, hand-start each bolt to avoid cross-threading, tighten in a star pattern with a calibrated torque wrench to the vehicle or wheel maker's figure, and avoid impact guns. Searches like "14x1.5 60 degree cone seat lug bolt," "55mm extended wheel bolt for spacers," and "17mm hex tapered lug bolt silver" describe exactly what this part does.
The manufacturer lists a black variant under 1455501SW with the same 55mm length, 60-degree taper, and 17mm hex. The part described here is the silver version.
The manufacturer lists a 1455501SET that includes a wheel lock. This listing is for the single bolt only.
Owners on user forums report that bolt-on spacers generally require longer fasteners than the factory bolts. Measure your spacer thickness and confirm the remaining thread engagement before choosing a length.
This is a straightforward bolt-for-bolt job that needs a 17mm socket or wrench, a calibrated torque wrench, and a way to lift and support the vehicle safely. Hand-start every bolt before tightening so the cone seat engages without cross-threading, then work in a star pattern to the torque specified by your vehicle or wheel manufacturer. Avoid impact guns, which can damage the threads and the seat. Owners on user forums commonly recheck torque after the first 100 miles, and it is worth doing that check after installing any new wheel fasteners or spacers.