The H&R 1455206SW is a black extended wheel bolt on the M14x1.5 thread, with a 52mm shank and a 19mm spanner head. The manufacturer lists it with a Porsche ball seat (R14) and sells it individually or as a box of 10. The manufacturer's configurator also lists a Porsche OE light-alloy rim application for this bolt family. Owners on user forums stress that the seat must match the wheel: verify whether the wheel calls for a 60-degree conical seat or the Porsche R14mm radius type. That makes this bolt a safer choice than a generic bolt with the wrong seat.
For a track or spacer build, the extra length matters. Owners on user forums note that factory-length lug bolts have 30mm of thread under the seat, and you adjust as needed for installed spacers. Before fitting, push a bolt into an unmounted wheel from the outside and check the thread that protrudes at the back. You should have at least as much thread as the bolt's diameter, but not too much more. Search terms that match this part include R14 ball seat Porsche lug bolt, M14x1.5 52mm black, and 996 997 Porsche wheel bolt.
The manufacturer lists an M14x1.5 thread with a Porsche ball seat (R14). Owners on user forums confirm that an R14 bolt is required for these wheels, so check your wheel seat before ordering.
The manufacturer lists a 19mm spanner size. Owners on user forums have reported that a 19mm socket did not fit some 992 bolts, so confirm the head fit with your own socket before you buy a full set.
This is a straightforward bolt-on job with a 19mm socket and a torque wrench. Owners on user forums cite 160 Nm for 992 lug nuts, but confirm the torque for your model with the manufacturer. Test-fit one bolt on the wheel before you torque the full set, because thread engagement is the usual failure point. Some Porsche sets include a single locking bolt per wheel that uses a special key, so keep that tool available when you swap hardware.