The H&R 1454703SW is a black 14 x 1.5 wheel bolt with a 47mm threaded length and a 17mm hex head, built with a VW/Audi ball seat. The manufacturer lists it with an R13 seat designation in its VW/Audi ball-seat range, so it targets wheels that call for that seat rather than conical or flat designs. Since the seat determines how a wheel centers on the hub, confirming it before you order matters more than anything else on the spec sheet.
Cheap generic bolts with the wrong seat are a false economy. Mismatched seat types can cause catastrophic failure through improper load distribution. A correctly seated H&R bolt in black finish gives you hardware that matches the wheel's seat geometry and dark rim styling. The manufacturer sells it individually and in a box of ten, which makes it practical to replace a full set or keep spares in the trunk for track days and wheel swaps.
For a DIY install, plan on a 17mm socket and a torque wrench. Do not lubricate the threads or seats, since lubrication changes the friction and skews torque readings. Run the bolts down by hand, then tighten in a star pattern. If you run wheel spacers, longer fasteners keep enough thread engaged, so check the bolt length against your setup. Re-check torque after the first 50 to 100 miles, and confirm the final figure in your owner's manual.
The manufacturer lists it as a VW/Audi ball seat, designated R13. Check that your wheels call for this seat before ordering, because a mismatched seat will not center the wheel correctly.
The manufacturer lists it as a single bolt and as a box of ten under the same part number family, so you can order one spare or a full set.
This is a straightforward bolt swap that still rewards care. Clean the threads and hub face, use a 17mm socket to start the bolts by hand, and tighten in a star pattern with a calibrated torque wrench. Avoid impact guns for the final pass, and never grease the threads. Confirm the torque figure for your vehicle in the owner's manual, and re-check after the first 50 to 100 miles of driving.