The H&R 1454702SW is a black M14x1.5 wheel bolt with a 47mm shank and a Mercedes-style ball (radius) seat, listed by the manufacturer as R14. Its 17mm hex head is the same spanner size as most factory Mercedes bolts, so it fits the standard tools in a typical kit. Choose it over a generic bolt when you need an OE-type ball seat that matches a Mercedes wheel's radius recess and a finish that stands up to brake dust and road salt. A cheap cone-seat bolt can look similar but may seat on an edge and loosen over time.
Check the seat type before you order, because a ball-seat bolt is the wrong part for most aftermarket wheels, which typically use a 60-degree cone seat. Confirm that your Mercedes model and wheel use the M14x1.5 ball-seat arrangement. If you are adding spacers, you will need longer bolts. Installation is straightforward with basic tools: start each bolt by hand to avoid cross-threading, avoid an impact wrench, and tighten in a star pattern with a calibrated torque wrench set to the vehicle manufacturer's wheel-bolt specification. Re-check torque after the first drive. Searches for "H&R 1454702SW," "M14x1.5 47mm Mercedes ball seat bolt," and "R14 radius lug bolt black" will find this exact part.
The manufacturer lists this bolt for a Mercedes ball (R14) seat. Aftermarket wheels usually have a 60-degree cone seat, which requires cone-seat bolts. Match the seat profile to your wheel before installing.
The manufacturer lists 47mm as the shaft length for this bolt. Shaft length must suit your hub and any wheel spacer, so confirm fitment before ordering a different length.
This is a bolt-on job that takes basic hand tools, a 17mm socket, and a calibrated torque wrench. Clean the hub face and bolt seats, thread each bolt in by hand, and tighten in a star pattern in stages. Do not use an impact gun, which can over-torque and damage threads or alloy wheels. Confirm that the bolt does not contact brake or ABS components behind the hub, and re-check torque after the first drive.