This H&R wheel bolt set includes ten black fasteners with an M14 x 1.5 thread, a 45.5 mm shank, and a 19 mm hex head. The seat is a 60-degree movable taper (conical) design. H&R lists this bolt in its wheel screw range, alongside the hardware it offers for its TRAK+ wheel spacer program. Once a spacer goes on, the stock bolt is usually too short to engage the hub properly, so an extended bolt in the correct length and seat style is what keeps the wheel secure. Buyers searching for extended conical seat wheel bolts, M14x1.5 black tapered lug bolts, or a 19mm hex wheel bolt set of 10 will find this is the matching format.
Buying the full set of ten makes more sense than piecing together single bolts, since every wheel position needs an identical bolt. The manufacturer's own guidance calls for the new bolt to be longer than the original by the spacer's thickness, so a correctly sized extended bolt is the safer choice over reusing factory hardware. Owners on user forums say keeping the 19 mm head is a common choice because it matches the factory spare-tire wrench. The black finish also gives a cleaner look behind an open-spoke wheel than the stock silver.
The manufacturer advises that the head of the new wheel screw must be identical to the one currently installed, so check the seat design on your existing bolt. The manufacturer also notes that the seat must match the wheel's bolt holes. Confirm the seat type with your wheel maker before ordering.
According to the manufacturer, new bolts must be longer than the original bolts by the width of the wheel spacer being used. Measure your spacer thickness and compare it with the original bolt length before choosing a length.
The manufacturer's installation guidance is to hand-start the bolts, snug them in a star pattern, and then tighten them with a torque wrench set to the wheel manufacturer's specification.
This is a moderate DIY job that needs a jack and stands, a 19 mm socket, and a calibrated torque wrench. Start by removing the original bolts and the wheel, then fit the spacer flush against the hub. Hand-thread each new bolt so it spins in freely, since forcing a bolt can cross-thread it. Snug all bolts in a star pattern, then torque them in the same sequence. The manufacturer also advises turning the wheel by hand afterward to confirm it rotates freely and that the bolts do not contact brake components such as ABS sensors. Make sure the hub surface is clean before assembly.