This is H&R's black M14x1.5 wheel bolt with a 40mm threaded length and a VW/Audi ball seat, the R13 seat that the manufacturer lists for this part. It is a lug bolt for aftermarket wheels that need a longer engagement than stock hardware provides. Shops searching for "14x1.5 40mm ball seat lug bolt," "R13 wheel bolt black VW Golf," or "extended wheel bolt for spacers" are looking for this exact spec. H&R's catalog lists this 40mm length alongside its other ball-seat lengths, so buyers can pick the length that matches their spacer thickness. The manufacturer also sells this bolt in a set of 10, which is the practical count for a four- or five-lug wheel setup.
The reason to choose this bolt over a generic one is the fit between the seat and the wheel. A correctly matched ball seat keeps the wheel centered and seated under load, and H&R's bolts are built as a matched system with its spacers and other wheel hardware. Before ordering, confirm the required thread length for your wheel and spacer combination. Use a 17mm hex socket and a calibrated torque wrench, and tighten in a star pattern to the vehicle or wheel manufacturer's specification. The manufacturer's general installation instructions call for re-checking the wheel bolts with a torque wrench after about 100 km of driving, and for renewing self-locking nuts and bolts when they are replaced.
The manufacturer lists this bolt with a VW / Audi ball seat designated R13, in a 14 x 1.5 thread size with a 17mm hex head.
The manufacturer's catalog lists the black 40mm VW / Audi ball bolt both as a single piece and as a set of 10 in a box.
Per the manufacturer's general installation instructions, the wheel bolts should be re-checked with a torque wrench after about 100 km of driving.
This is a bolt-on job that most home mechanics can complete with a jack, jack stands, a 17mm hex socket, and a calibrated torque wrench. Clean the threads and the hub seats before installing, and start each bolt by hand so it does not cross-thread. Snug all bolts in a star pattern, then torque them in stages to the vehicle or wheel manufacturer's specification rather than using an impact gun for the final torque. Confirm the bolt length against your spacer thickness before you begin, because a bolt that is too short will not engage enough thread and one that is too long can interfere with brake or ABS components. Re-check the torque after the first 100 km.