The H&R 1454001SW is a 14 x 1.5 wheel bolt with a 40mm threaded shank, a 60-degree tapered (conical) seat, and a 17mm hex head in black. The manufacturer's catalog lists the 40mm tapered version of this bolt, with the black SW suffix, sold per bolt or in a box of 10. Its body is steel. Compared with a stock bolt, the 40mm reach is the reason to buy it: extended lengths are typically needed when wheel spacers are fitted, because the spacer thickness shortens how far the original bolt can engage the hub. Buyers searching for a 14x1.5 tapered black lug bolt for a 40mm spacer setup, or a spare-bolt kit for an H&R track or street spacer install, will find this part fits that need at a low per-bolt cost.
Fitment hinges on two things: the thread pitch and the seat. The bolt uses M14 x 1.5 threads, so the hub must be tapped for that pitch, and the 60-degree cone must match the bolt holes in your wheel. A ball-seat wheel will not seat correctly with a conical bolt. Because the bolt is sold as universal-fit, confirming thread pitch and seat profile against your wheel and hub is the buyer's responsibility. The manufacturer's spacer guidance also states that the stock bolt must not protrude beyond the spacer's width, so measure your spacer before ordering. For installation, hand-start each bolt to avoid cross-threading, tighten with a torque wrench in a star pattern to your vehicle's specified value, and avoid impact guns, which can damage the threads and seat.
The manufacturer's catalog lists the SW-suffix part as the black version of the 40mm tapered bolt. The manufacturer's configurator lists the plain 1454001 as silver, so confirm the finish and article number with the manufacturer before ordering if color matters to you.
The manufacturer's spacer guidance ties bolt length to spacer width, so a longer bolt is generally needed when a spacer is fitted. Measure your spacer thickness and the protrusion of your current bolt to confirm that 40mm gives adequate thread engagement without contacting components behind the hub.
Replacing lug bolts is a straightforward job with basic hand tools, a 17mm socket, and a torque wrench. Raise the vehicle safely and remove the wheel, then clean the hub and wheel mating surfaces before fitting the new bolts. Hand-thread each bolt first to avoid cross-threading, and tighten in a star pattern to the torque value in your vehicle or wheel manufacturer's specification. Avoid impact wrenches, which can damage the threads and seat. After the first few hundred miles of driving, re-check torque, because bolts can settle. If you are installing spacers, confirm that the 40mm length leaves adequate thread engagement and does not contact brake or ABS components behind the hub.