The H&R 1454002SW is a black M14x1.5 wheel bolt, 40mm long, with a Mercedes-type ball seat and a 17mm hex head. It is listed by H&R Springs as a 14 x 1.5, 40mm Mercedes Ball bolt with a 17mm head, sold individually or in a box of 10. It is built for wheel setups that need a longer fastener than the factory bolt, most often when a spacer is added. Buyers searching for an extended Mercedes ball seat lug bolt, 14x1.5x40 black, or a 17mm hex spacer bolt will find this is the correct length and thread for that job.
The main reason to choose this bolt over reusing factory hardware is thread engagement. The length of the existing screw sticking out of the rim must be smaller than the width of the wheel spacer, according to H&R's spacer guidance. A 40mm bolt gives you the reach to clear a spacer and still seat fully in the hub. Cheaper generic bolts rarely offer a documented seat type and thread specification, so you can confirm the ball seat matches your wheel's bolt holes before you commit. Check fitment against your wheel and spacer thickness before ordering.
The manufacturer's spacer guidance says the stock bolt must not protrude past the spacer's width, so a longer bolt is required once a spacer is fitted. Check your spacer thickness against the bolt length before installing.
Yes. The manufacturer's catalog lists the 1454002SW as a single bolt and also as a set of 10.
The manufacturer's install instructions call for retightening the wheel bolts after about 100 km using a torque wrench.
This is a straightforward DIY job with basic hand tools and a torque wrench. Clean the hub and bolt threads, keep them dry, and hand-start each bolt so it spins in freely without cross-threading. Snug all bolts in a star pattern, then spin the wheel to check for rubbing or interference before the final torque. Torque to your vehicle or wheel manufacturer's specification in a star pattern, avoiding an impact gun for final tightening. Renew all self-locking nuts and bolts and use the correct tightening torque. Re-check torque after the first 100 km. Confirm the final torque value with the vehicle or wheel manufacturer, because the specification is not listed on this page.