Free Shipping on Orders Over $99  ·  No Code Needed

H&R Wheel Bolts Type 14 X 1.5 Length 38mm Thread Type 60 Degree Tapered Head 17mm

*Photo may not represent actual product

The H&R 1453801 is a 14 x 1.5 wheel bolt with a 38mm threaded length, a 60-degree tapered seat, and a 17mm hex head, as catalogued in the manufacturer's wheel bolt range. Its extra reach matters most with spacers: the stub of existing bolt projecting past the rim must be shorter than the spacer's width, per the manufacturer, which is why a longer bolt is needed for spacer setups. Without a spacer, it works as a direct replacement, provided the thread pitch and seat type match your hub.

Why choose this over a generic bolt of similar length? A catalogued H&R part removes the guesswork of matching a 60-degree cone seat, and the thread pitch and seat type are what keep a wheel clamped. The manufacturer also sells movable taper head 60° variants, so confirm seat style before ordering. Installation is a routine roadside-friendly job: a 17mm socket, a torque wrench, and a jack and stands. Keep hub threads clean, avoid lubricating them, hand-start every bolt, and tighten in a star pattern to the figure in your owner's manual. Long-tail searches: H&R 14x1.5 38mm tapered wheel bolt, M14x1.5 spacer bolt, 60 degree conical seat lug bolt, 17mm hex wheel bolt.

  • Thread size: M14 x 1.5
  • Shank length: 38mm
  • Seat type: 60° tapered (conical)
  • Hex head: 17mm
  • Finish: Silver (confirm with the manufacturer before ordering)
  • Quantity: Single bolt (sets of 10 also offered)
  • Application: Universal 14 x 1.5 hub; verify hub thread and seat for your vehicle

FAQ:

Can I run the 38mm H&R 1453801 with wheel spacers?

The manufacturer's spacer guidance says the bolt section that projects past the rim must be shorter than the spacer's width. Measure your spacer and the bolt projection before ordering, and confirm with the manufacturer if you are unsure.

Is this bolt a direct replacement for the factory bolt on my car?

The manufacturer catalogues this part as a 14 x 1.5 bolt with a 60-degree tapered seat. Whether it fits your specific hub depends on thread pitch, seat style, and length, so confirm fitment with the manufacturer before installing.

Installing it yourself

Installation is a straightforward DIY job requiring a 17mm socket, a torque wrench, and a safe jacking setup. Remove the wheel, clean the hub threads and seat, and check that each bolt spins freely by hand before tightening to avoid cross-threading. Do not apply lubricant to the threads or seats, since it changes the torque reading. Tighten in a star pattern to the torque value in your owner's manual, then recheck the torque after the first 50 to 100 miles. If you are installing spacers, measure the bolt projection before final tightening.

  • MPN: 1453801
  • Manufactured by: H&R
  • Units per SKU: 1
  • In Stock: 96
Exclusive member pricing Free membership — sign in to see your price
Join Free →

$4.45

MSRP / List price
Member Price
Your price after signing in
$4.45
In Stock — ships same day if ordered before 5pm PST
Add to Cart:
MPN
1453801
Manufacturer
H&R
Availability
In Stock (96)
Ships Same Day
Order before 5pm PST and this product ships same day
Member Pricing
Easy Returns
Expert Support
Secure Checkout