The H&R 1453503SW is a black 14 x 1.5 wheel bolt with a 35mm threaded length, a 17mm hex head, and a VW / Audi ball seat. The manufacturer lists it as a 14 x 1.5, 35mm, VW / Audi Ball, 17mm, Black part with an R13 seat radius, and it is sold individually or in a box of 10. The R13 seat radius is the main reason to match this part exactly. A bolt with the wrong seat geometry can seat poorly against the wheel, so a close-enough generic bolt is a risky shortcut on a performance car.
The 35mm shank matters most when a spacer is in the stack. H&R's spacer guidance says the spacer belongs between the wheel and the hub, using longer bolts that are not included. That means stock bolts often cannot reach the hub with a spacer installed. Before buying, confirm the bolt length you need for your spacer and wheel, and confirm the seat type against your wheels. Owners on user forums commonly report that the bolt must reach full thread engagement in the hub. Because fitment details can vary by application, check with the manufacturer before ordering.
The manufacturer lists the silver 1453503 with the same 14 x 1.5 thread, 35mm length, VW / Audi ball seat, and 17mm head. The 1453503SW differs in its black finish.
According to the manufacturer's spacer guidance, a spacer that sits between the wheel and hub requires longer bolts, which are ordered separately. Confirm the exact length your spacer requires with the manufacturer.
Installation is straightforward for a home mechanic. You will need a 17mm socket and a calibrated torque wrench. H&R's TRAK+ guidance recommends placing the spacer fully seated and flush against the hub, then hand-threading the new bolts so they spin in freely to avoid cross-threading. Snug the bolts in a star pattern with a hand wrench. Before final tightening, spin the wheel to check for rubbing or interference. Then tighten the bolts in a star pattern with a torque wrench set to the wheel manufacturer's specifications. Recheck torque after the first drive, since new wheel fasteners can settle.