Free Shipping on Orders Over $99  ·  No Code Needed

H&R Wheel Bolts Type 14 X 1.5 Length 30mm Type Tapered Head 17mm

*Photo may not represent actual product

The H&R 1453001 is a 14 x 1.5 wheel bolt with a 30mm threaded shank and a 60-degree tapered seat, driven by a 17mm hex head. The manufacturer lists it as a tapered-seat part, so it is matched to wheels built for a cone seat, not to ball-seat or flat-seat designs. Compared with a generic bolt of unknown seat geometry, a published seat spec and a known thread pitch remove most of the guesswork when you fit aftermarket wheels or spacers. At a manufacturer list price of about $4.45 each, the cost is small next to the risk of a wheel working loose. Search terms this part matches include M14x1.5 60 degree tapered lug bolt, 30mm wheel bolt, and H&R 1453001 wheel spacer bolt.

Before ordering, check the seat type printed on your wheel or in its specs, and measure how much thread your hub and spacer require. The 30mm length is a common choice for thin spacer setups, but confirm engagement against the spacer maker's instructions. For installation, clean the hub and wheel seating faces, hand-thread each bolt to avoid cross-threading, and tighten in a star pattern with a calibrated torque wrench set to the vehicle manufacturer's wheel-bolt specification. Avoid impact guns, which can damage the threads and seat, and recheck torque after the first few drives.

  • Thread Size: M14 x 1.5 (listed as 14 x 1.5)
  • Thread Length: 30mm
  • Seat Type: 60° tapered (cone)
  • Head Size: 17mm hex
  • Finish: Black version is listed as 1453001SW; the base 1453001 listing does not specify color
  • Pack Options: Single bolt or set quantities, box of 10 available

FAQ:

What seat type does the H&R 1453001 use?

The manufacturer lists a 60-degree tapered (cone) seat for this bolt. Confirm that your wheels use a matching cone seat before installing, because ball-seat wheels require different hardware.

Is the black version the same bolt?

The manufacturer lists the black finish under part number 1453001SW, while the base 1453001 listing does not state a color. If finish matters for your build, verify it with H&R before ordering.

What torque should I use with these bolts?

Torque to your vehicle manufacturer's published wheel-bolt specification using a calibrated torque wrench, tightening in a star pattern. A specific torque figure for this H&R part was not confirmed in the manufacturer material reviewed, so check with H&R if you need one.

Installing it yourself

This is a manageable job for a home mechanic with the wheel off the hub. You will need a 17mm hex socket, a calibrated torque wrench, a wire brush for cleaning the hub threads and seat, and a way to support the vehicle safely. Hand-start every bolt so the threads seat straight, since cross-threading is the most common mistake. Check that the seat type matches your wheel, because a mismatched seat can look fine while clamping poorly. If you are running spacers, make sure the bolt length gives adequate thread engagement with both the spacer and the hub, and recheck torque after the first drive.

  • MPN: 1453001
  • Manufactured by: H&R
  • Units per SKU: 1
  • In Stock: 31
Exclusive member pricing Free membership — sign in to see your price
Join Free →

$4.45

MSRP / List price
Member Price
Your price after signing in
$4.45
In Stock — ships same day if ordered before 5pm PST
Add to Cart:
MPN
1453001
Manufacturer
H&R
Availability
In Stock (31)
Ships Same Day
Order before 5pm PST and this product ships same day
Member Pricing
Easy Returns
Expert Support
Secure Checkout