The H&R 14253101SW is a 31mm M14 x 1.25 wheel bolt with a 60-degree tapered seat and a 17mm hex head, finished in black. Because the seat has to mate with the cone in your wheel's bolt holes, confirming seat style before ordering is what prevents a poor fit. The manufacturer also notes that its wheel screws differ by collar design, so a taper head should not be swapped for a flat or round one. H&R positions this length for use alongside its spacers, where a longer fastener is often required to reach the hub, which makes it a better match than a generic bolt cut to a guessed length.
Fitment is the step to verify. The manufacturer stresses that a bolt needs enough screw-in depth to hold the wheel securely, so a thread length that looks close is not enough on its own. For spacer setups, the manufacturer states that the bolt's thread length must match the spacer's thickness. Owners fitting H&R's Trak+ spacers follow a simple sequence: seat the spacer flush, hand-thread the longer bolts to avoid cross-threading, then tighten in a star pattern to the wheel maker's torque figure. Searchers looking for an M14x1.25 60-degree tapered 31mm black lug bolt, a spacer-length extended wheel bolt, or a 17mm hex H&R wheel screw will find this part's specs match.
The manufacturer states that the thread length of its wheel bolts must always match the thickness of the wheel spacer. Its wheel screw guidance also says to add the spacer thickness to the existing shaft length to determine the new bolt length.
Yes. The manufacturer notes that screw collar and head designs differ between taper, flat, and round types, and that the seat must fit the wheel's bolt holes precisely. Confirm your wheel's seat style before ordering.
The manufacturer lists both a single bolt and a 14253101SW SET, which is a box of 10 pieces.
Swapping these bolts is a straightforward job for a home mechanic with a jack, stands, and a torque wrench, although the wheel must come off to fit a spacer. Hand-thread each bolt first so it spins in freely, since cross-threading is the most common mistake the manufacturer's instructions warn against. Tighten in a star pattern to the torque value in your vehicle or wheel maker's specification. The manufacturer's spacer instructions also call for re-checking wheel bolt torque with a torque wrench after the initial break-in period.