The H&R 14253501SW is a black M14 x 1.25 wheel bolt with a 35mm shank, a 60-degree tapered seat and a 17mm hex head. The manufacturer groups it with its other 14 x 1.25 tapered-seat bolts, so thread pitch, seat type and head size are the first things to check against your wheels. Its main value is as the extended-length bolt for a spacer setup, where the factory bolt is often too short to reach the threads through the added thickness. Compared with an unspecified generic lug, this bolt has a published thread, seat and length to verify before you buy.
Search terms this bolt matches include M14x1.25 tapered lug bolt, 35mm black wheel bolt, 17mm hex lug for wheel spacers and H&R 14x1.25 60 degree wheel bolt. Fitment should be confirmed from the thread, seat and head values rather than from vehicle model alone. Confirm the seat type with the manufacturer before ordering, because its catalog data is not fully consistent for this part number.
The manufacturer states that its DR series spacers fit between the wheel and hub and require longer wheel bolts ordered separately. It also advises verifying the bolt head style and shaft length before ordering.
The manufacturer's bolt listing gives a 60° tapered seat for 14253501SW. However, its configurator also lists a black 35mm M14 x 1.25 bolt under a round-head description, so details vary. Confirm the seat type with the manufacturer before ordering.
The manufacturer advises tightening bolts in a star pattern with a torque wrench set to the wheel manufacturer's specification. It does not publish a single torque value for this bolt, so use your wheel maker's figure.
Installation is a moderate DIY job that needs a jack, stands, a torque wrench and a 17mm socket. Remove the wheel, seat the spacer fully against the hub, and hand-thread each new bolt so it spins freely and does not cross-thread. Snug the bolts in a star pattern, spin the wheel to check for rubbing or interference, then torque in a star pattern to your wheel maker's specification. Per the manufacturer's install tips, this sequence applies to its spacers. Owners on user forums have applied a light coat of anti-seize to the hub and bolt contact surfaces, and note that the 17mm head differs from the 19mm head on many factory spare-tire wrenches, so check what tools you have on hand.