The H&R 1255502 is an M12 x 1.5 lug bolt with a 55mm shank, a 17mm hex head, and a round-head R12 (Mercedes ball) seat. H&R specifies this length for its DR-series wheel spacers, which sit between the wheel and hub and need longer bolts to reach the hub through the added thickness. Owners on user forums note that stock Mercedes bolts are around 28mm, so an OE bolt will not reach the hub through a spacer. This is a long-tail fit for R12 ball-seat Mercedes and VW/Audi spacer setups. Buyers searching for an M12x1.5 R12 ball seat 55mm lug bolt or a DR spacer bolt will find this to be the correct length.
Choosing this H&R bolt over a generic one comes down to fit certainty. The manufacturer says replacement bolts must be longer than the originals by the width of the spacer, and the head style must match the original bolt, so a matched H&R part removes most of the guesswork. Owners on user forums consistently point to H&R as a reputable source for ball-seat bolts and advise checking the steel grade marking on any alternative. Spending a little more on a correctly sized bolt costs less than a damaged wheel seat or a stripped hub.
For DIY installs, hand-thread each bolt to avoid cross-threading, snug them in a star pattern, spin the wheel to check for interference, then torque to the wheel manufacturer's specification with a torque wrench. Rear hubs leave little room: owners on user forums report that longer bolts can contact parking brake components, and the bolt tip behind the wheel should not protrude beyond the spacer depth. Confirm your wheel seat radius before ordering.
Not as a like-for-like swap. The manufacturer states that bolts used with its DR spacers must be longer than the originals by the width of the spacer, so the 55mm length is intended for spacer applications.
Details vary. Owners on user forums report that longer bolts on some Mercedes rear hubs can contact parking brake components, and some have trimmed the bolt tip to clear it. Confirm clearance with the manufacturer before installing.
User forum discussions show mixed views on running R12 ball-seat bolts in R14 seats. Check your wheel seat type and confirm compatibility with the manufacturer before installing.
This is a bolt swap that comes with a spacer install, so it is a moderate DIY job for someone comfortable with lug torque. Remove the wheel, fit the spacer fully flush against the hub, then install the new longer bolts by hand first. Tighten in a star pattern with a torque wrench set to the wheel maker's specification, and re-check torque after the first 50 to 100 miles, as owners on user forums recommend. Use a light coat of anti-seize on the threads only if the wheel maker permits it.