If your wheels use a 12 x 1.5 ball-seat fastener and you need a longer bolt, H&R part 1254502 is a 45mm Mercedes-style ball seat wheel bolt with a 17mm hex head. H&R's listings describe it as a round-head R12 design. Cheap generic bolts can look similar, but the seat radius, thread pitch, and length determine whether a wheel seats flat and stays tight under load. Matching the H&R specification removes most of that guesswork. If you prefer a non-silver finish, the black SW variant is listed under a separate part number.
Owners on user forums report that original 12x1.5 R12 ball-seat bolts were fitted to Bundt-style wheels and many early Mercedes-Benz models, so confirm your wheel seat and hub thread before ordering this 12x1.5 ball seat lug bolt. Thread pitch matters: forum members warn that 12x1.25 and 12x1.5 bolts are not interchangeable and can cross-thread. Owners who run wheel spacers have used longer bolts for clearance, but rotate the wheel by hand to confirm the extra thread does not contact parking-brake parts. Torque figures vary by model, with owners citing 110 Nm or 130 Nm, so check your owner's manual before tightening.
Owners on user forums report that 12x1.5 R12 ball-seat bolts were original equipment on Bundt-style wheels and many early Mercedes-Benz models. Confirm your wheel's seat type and hub thread before ordering.
No. User forums warn that 12x1.25 and 12x1.5 bolts are not interchangeable, and mismatched threads can cross-thread or damage the hub.
Torque varies by model. Owners on user forums commonly cite 110 Nm or 130 Nm, so use the value in your owner's manual.
Replacing these bolts is a manageable job for a home mechanic with a 17mm socket and a calibrated torque wrench. Raise the vehicle safely, remove the wheel, and check that the new bolt seats fully in the wheel's ball seat. Clean the threads and seats first, as owners on user forums recommend. Start each bolt by hand, then tighten in a star pattern to your owner's manual figure, and recheck torque after the first drive.