The H&R 1255002 is a replacement wheel bolt with an M12x1.5 thread, a 50 mm shank, and a Mercedes ball seat, driven by a 17 mm hex head. H&R's catalogue lists it in silver, with a black version (1255002SW) available for buyers who want a different look. It is built for wheels that use a ball-seat bolt, so it suits owners who need a longer bolt for a wheel spacer rather than a stock-length replacement.
The reason to pay for this bolt over a generic bin part is seat geometry and length control. A spacer pushes the wheel outward, so the manufacturer's guidance is that replacement bolts must be longer than the originals by the spacer's width, with the head type matched to the existing bolt. Owners on user forums warn that a ball seat's radius has to suit the wheel: an R12 seat can sit too deeply in R14 wheels, so confirm the wheel's seat type before ordering.
Installation is a basic job with a 17 mm socket and a torque wrench. Per the manufacturer's safety guidance, M12x1.5 bolts need roughly 6.5 turns of thread engagement, about 10 mm of load-bearing shaft. Before final torque, turn the wheel by hand to check clearance inside the hub, and make sure the bolt does not contact ABS sensor wiring or brake components.
Yes. The manufacturer states that new bolts must be longer than the original bolts by the width of the wheel spacer used. Its DR-system spacers also require longer wheel bolts, ordered separately.
The manufacturer lists a black-finished Mercedes ball R12 bolt under part number 1255002SW, with the same 50 mm length, M12x1.5 thread, and 17 mm head.
Owners on user forums report that R12 and R14 ball seats are not interchangeable, since the seat radius has to match the wheel. Confirm your wheel's seat type with the manufacturer before installing.
This is a straightforward swap for a home mechanic with a 17 mm socket, a torque wrench, and a way to lift and support the vehicle safely. Hand-start each bolt so the threads do not cross, then tighten evenly. Remember that the manufacturer's guidance asks for a check of hub clearance by turning the wheel by hand before the final torque. If you are fitting spacers, verify the bolt length against the spacer thickness first, since a bolt that is too short will not engage enough thread, and one that is too long can contact the hub or brake parts.