The H&R 1254001SW is a black M12x1.5 wheel bolt with a 40mm thread length, a 60° tapered (cone) seat, and a 17mm hex head. The manufacturer lists it in its 12 x 1.5 tapered-seat range as an extended-length bolt for installations where a wheel spacer or aftermarket wheel needs more thread reach than factory hardware offers.
Factory bolts often come up short once a spacer adds thickness, and the 40mm shank gives the threads room to engage the hub properly while the matching cone seat seats the wheel the way the original hardware does. Choosing a manufacturer-listed H&R part with published dimensions is safer than an unbranded bolt with unknown thread pitch or seat geometry, and the black finish suits dark or blacked-out wheels. Searchers looking for a 40mm tapered lug bolt, an M12x1.5 60 degree cone seat wheel bolt, or an extended wheel spacer bolt with a 17mm hex will find this part's specs match those terms.
The manufacturer's catalogue lists the same 12 x 1.5, 40mm, 60° tapered, 17mm specification for both. The SW suffix identifies the black version.
The manufacturer lists a 17mm spanner size for this bolt.
The manufacturer's general installation instructions call for retightening wheel bolts after about 100 km of driving, using a torque wrench.
This is a manageable job for a home mechanic comfortable removing wheels, and it needs a 17mm socket, a calibrated torque wrench, and a wire brush for cleaning the hub face and threads. Confirm your wheel uses a 60° cone seat before you start, because a mismatched seat prevents proper torque. Fit the bolts dry and clean, start them by hand, and snug them in a star pattern before final torquing to your vehicle or wheel manufacturer's specification. Avoid impact guns for final torque. If you are running a spacer, check that the longer bolt does not bottom out in the hub and that it clears brake and ABS components. Re-check the torque after the first 100 km.