The H&R 1254002 is a 12 x 1.5 wheel bolt with a 40mm thread length, a 17mm hex head, and a Mercedes ball seat, made for Mercedes-Benz wheels that use a ball-seat lug. H&R sells it within its wheel bolt and stud line, and a black-finished version, 1254002SW, is listed separately. Paying more than a generic lug is worth it because seat radius, shank length, and thread engagement determine whether a wheel clamps evenly. The manufacturer publishes minimum-engagement guidance for M12 x 1.50 fasteners, which gives you a measurable standard instead of guesswork.
Fitment depends on the wheel, not just the car. Owners on user forums report that many aftermarket wheels use conical seats, which a ball-seat bolt will not properly match, and that ball seats of different radii (R12 versus R14) do not interchange cleanly. Before ordering, check the seat type and hole geometry of your wheels, and compare the bolt's length against your original hardware. Searches for "12x1.5 Mercedes ball seat lug bolt 40mm," "H&R 1254002 wheel bolt," and "R12 ball seat wheel bolt for Mercedes" will lead you to the right part, but confirm the seat against your rim before you torque anything.
Owners on user forums report that many aftermarket wheels use conical seats rather than ball seats, so a ball-seat bolt may not seat correctly in those wheels. Confirm the seat type with the wheel maker before installing.
The manufacturer's guidance for M12 x 1.50 hardware is a minimum of about 6.5 turns, roughly 10mm of load-bearing shaft length. The manufacturer also warns that the bolt must not contact ABS sensors or other brake-system components.
Per the manufacturer, new bolts must be longer than the original bolts by the width of the wheel spacer being used.
This is a straightforward bolt swap that needs a 17mm socket and a torque wrench. Before final torque, turn the wheel by hand: it should rotate freely, with no contact against the hub, brake parts, or ABS components. The manufacturer notes that some vehicles, including rear-axle Mercedes applications, allow only about 2mm of clearance, so check this carefully. Torque the bolts to your vehicle or wheel maker's specification with a torque wrench rather than an impact tool, and re-check after the first drive. The manufacturer's torque value for this specific part was not confirmed during research, so verify it before installation.