The H&R 1253501 is a 12 x 1.5 wheel bolt with a 35mm thread length, a 60-degree tapered (cone) seat, and a 17mm head. It is built for wheel spacer setups and for direct replacement of factory bolts that use the same taper. A buyer who runs spacers needs a longer shank than stock, and the manufacturer's own guidance is to add the spacer thickness to the length of the existing bolt. This 35mm length gives a practical step up when a spacer calls for more reach than the factory fastener provides. Because the bolt matches the taper, it seats correctly in cone-seat wheels, where a mismatched ball-seat bolt would not. Searchers looking for a 12x1.5 tapered spacer bolt, M12x1.5 35mm cone seat lug bolt, or 17mm hex wheel bolt for H&R spacers will find the exact spec here.
Fitment depends on the hub and wheel, so check before you order. The manufacturer says the new bolt head must be identical to the one already installed, so match the taper against your current hardware. Confirm the seat type and thread pitch on your existing bolts, then check the spacer or wheel thickness to set the length. For installation, clean the hub and contact faces of corrosion first, seat the spacer or wheel fully against the hub, and then tighten in a star pattern to the torque value listed for your vehicle or wheel. Use a torque wrench for the final tightening rather than an impact gun.
The manufacturer states that the head of the new wheel bolt must be identical to the head of the bolt currently installed. Confirm that your existing bolts use a 60-degree tapered seat and a 12 x 1.5 thread before ordering.
The manufacturer advises adding the thickness of the spacer to the shaft length of your current wheel bolt. The result is the minimum length needed for the new bolt, so measure your spacer and the existing bolt before selecting the 35mm option.
The manufacturer lists 1253501 in silver and 1253501SW in black, with the same 12 x 1.5 thread, 35mm length, 60-degree tapered seat, and 17mm head. The only difference is the finish.
This is a straightforward job for a home mechanic with a 17mm socket, a torque wrench, and a jack with stands. Owners on user forums who have fitted wheel spacers recommend cleaning rust off the axle stub and hub face before assembly, and mounting the spacer first so it sits flush against the hub. Confirm that the new bolts will not contact brake or hub components behind the mounting surface. Tighten the bolts in a star pattern, finish with a torque wrench at your vehicle or wheel maker's specification, and recheck torque after the first few drives.