The H&R 1253501SW is a single M12 x 1.5 wheel bolt with a 35mm shank, a 60-degree tapered (cone) seat, a 17mm hex head, and a black finish. The manufacturer's listing for this part number matches those dimensions. It is a practical choice for drivers running wheel spacers or aftermarket wheels that need a longer bolt than stock, and it lets you keep the same thread and seat geometry. Compared with a cheap generic bolt, a manufacturer-listed part gives you a known thread pitch, seat angle, and length to check against your hub. Buyers searching for a 12x1.5 tapered black lug bolt, a 35mm wheel spacer bolt, or an M12x1.5 60-degree cone seat bolt will find this matches. Confirm the seat type on your existing bolt or wheel before ordering, because a tapered bolt will not seat correctly in a round or flat seat.
This bolt suits DIY owners who are replacing stock hardware during a wheel or spacer install. Hand-threading each bolt and tightening in a star pattern with a torque wrench helps avoid cross-threading and uneven clamp load. Torque the bolts to the wheel or spacer manufacturer's specification. Because fitment depends on hub thread pitch, seat type, and the total length needed for your spacer or wheel setup, the manufacturer's guidance is to verify these before installation. Owners on user forums commonly use longer H&R bolts when spacers are fitted, so check the required length against your spacer thickness.
The manufacturer states that spacers mounted between the wheel and the hub use longer wheel bolts than the stock set. When ordering, you should specify the cone type and the extra length you need for your spacer.
The manufacturer lists this part with a tapered 60° seat. Before installation, check that your existing bolts or wheel seat are also tapered, since the manufacturer's guidance is to verify the seat type to match the application.
This is a straightforward job for a home mechanic with a jack, stands, and a torque wrench, but it requires care with thread alignment. Clean the hub and wheel seating surfaces before fitting. Hand-thread each bolt so it spins in freely, then snug them in a star pattern and finish with a torque wrench set to the wheel or spacer manufacturer's specification. Owners on user forums commonly re-check torque after the first 50 to 100 miles, which is the same break-in advice given for new wheel installs. Avoid impact guns on these bolts, since they can damage the threads and seat area.