The H&R 1252801 is a 12 x 1.5 metric wheel bolt with a 28mm thread length, a 17mm hex head, and a 60-degree tapered (cone) seat. The manufacturer lists it alongside its ball-seat siblings, the Mercedes-style 1252802 and the VW/Audi-style 1252803, so the seat geometry is the main reason to pick this version. A branded bolt with a published seat angle and length removes guesswork that a generic hardware-store bolt of unknown seat angle leaves open. Matching the seat to the wheel is what keeps the wheel centered and clamped under load.
Fitment depends on the wheel's seat, not just the vehicle, so confirm the bore is cone-seated before ordering. Mixing seat angles is a real risk: 60-degree lugs on a 45-degree seat cause edge contact that concentrates stress. The 28mm length should be checked against your wheel and any spacer stack, since a bolt that is too short will not fully engage the threads. For DIY installs, a 17mm hex socket, a torque wrench, and a star tightening pattern are the essentials. Torque to the vehicle or wheel maker's published specification, and recheck after the first short drive. Searchers looking for a 12x1.5 tapered lug bolt, a 60 degree cone seat wheel bolt, or an H&R 1252801 replacement will find this listing matches those terms.
The manufacturer lists the 1252801 with a 60-degree tapered seat, while the 1252802 is its Mercedes ball-seat version. Both are 12 x 1.5 at 28mm with a 17mm head, so the seat type is the deciding factor. Use the tapered version only on cone-seated wheels.
The manufacturer's applications page lists tapered 12 x 1.5 bolts from 22mm through 60mm, including 24mm, 29mm, 35mm, and 50mm. Confirm the length your wheel and spacer setup requires before ordering.
According to the manufacturer's listing, black versions carry an "SW" suffix, such as 1253001SW. The 1252801 has no such suffix, so it is not listed as the black variant.
This is a straightforward job for a home mechanic with basic tools. You will need a 17mm hex socket, a torque wrench, and a way to lift and support the vehicle safely. Thread the bolts in by hand first to avoid cross-threading, then tighten in a star pattern in stages, finishing with the torque value from the vehicle or wheel manufacturer. Avoid impact tools for the final tightening, since they make accurate torque impossible. Recheck torque after the first short drive, as wheel seats can settle. Never mix seat types on the same wheel.