The H&R 1454207ASW SET is a ten-bolt set of black 14 x 1.5 wheel bolts with a 42mm thread length, a 17mm hex head, and an Audi removable ball seat (R14). The manufacturer's catalog cites Audi Q3 and Q5 as example applications, and the longer shank gives you thread reach for hub-mounted spacers, where stock-length bolts can fall short. Buying the full set of ten covers all four corners plus a spare, which is cheaper per bolt than replacing them one at a time. Because the seat radius is the detail that causes trouble, check your existing bolt before ordering. Owners on user forums say Q5 and Q7 factory wheels generally use R14 while most other Audi models use R13, so a mismatched seat can seat poorly against the wheel.
Installation comes down to choosing the right length and seating the bolts cleanly. The manufacturer's spacer guidance says the new bolt length should account for the spacer thickness added to your original bolt, so measure before you buy. The manufacturer's install tips also call for fully seating the spacer and hub, hand-threading each bolt so it spins freely to avoid cross-threading, snugging them in a star pattern, and finishing with a torque wrench set to the wheel maker's specification. Recheck torque after the first short drive, since spacer and wheel stacks can settle.
The manufacturer lists this set with an Audi removable ball seat, R14. Owners on user forums report that Q5 and Q7 factory wheels use R14, while most other Audi models use R13, so compare the seat radius of your existing bolt before ordering.
The manufacturer states that its wheel spacers are mounted using longer wheel bolts, which are sold separately. It advises selecting the new length by adding the spacer thickness to the original bolt length.
This listing is the set of ten bolts. The manufacturer's single-bolt part number with the same thread, length, and seat specifications is 1454207ASW.
Plan on a standard hand-tool job with a 17mm socket and a torque wrench. Lift the vehicle safely, remove the wheel, and clean the hub and spacer contact faces so the spacer seats flush before the wheel goes back on. Hand-start each new bolt so it spins in easily, which prevents cross-threading into the hub or spacer. Snug the bolts in a star pattern, spin the wheel to check for rubbing or interference, then torque to the wheel manufacturer's specification. Confirm the bolt heads do not protrude past the spacer and that the ball seat matches your wheel before you start.