The H&R 1454703SW is a black wheel bolt in M14x1.5 thread with a 47mm shank, a 17mm hex head, and a VW/Audi ball seat. It is built for VW and Audi wheels that use ball-seat fasteners, and its extra length suits owners who run wheel spacers. The manufacturer states that its DR-series spacers need longer wheel bolts ordered separately, so a stock bolt that is too short can leave the thread engagement inadequate. Choosing this 47mm ball-seat bolt over a generic bolt matters because the seat geometry has to match the wheel. A mismatched seat can seat poorly and lose clamp load.
Search terms this part matches include "H&R 47mm ball seat lug bolt," "M14x1.5 VW Audi wheel bolt black," and "47mm wheel bolts for spacers." Before you order, confirm the seat type on your wheels, since ball-seat and conical-seat fasteners are not interchangeable. Owners on user forums who run VW wheels with ball-seat bolts generally keep the factory torque figure, and they advise checking the owner's manual before you tighten.
The manufacturer states that its DR-series spacers fit between the wheel and hub and require longer wheel bolts, which are ordered separately. Check the spacer thickness against the bolt length before you install.
This bolt uses a VW/Audi ball seat. Confirm that your wheels use a ball seat before fitting, because a ball-seat bolt will not seat correctly in a conical-seat wheel.
Installation is a straightforward job for a home mechanic with basic hand tools. You will need a 17mm hex socket, a calibrated torque wrench, and a way to lift and support the car safely. Remove the old bolts and clean the hub and wheel contact surfaces. Start each bolt by hand in a star pattern, then lower the vehicle so the wheel carries its weight before final torque. Use the torque value in your owner's manual, and avoid an impact wrench for final tightening. Recheck torque after the first short drive, and again after roughly 50 to 100 miles, because new wheel fasteners can settle.