The H&R 1454501SW SET is a ten-piece kit of black 14 x 1.5 wheel bolts. The manufacturer's listing gives a 45mm length, a tapered (60º) seat, and a 17mm head. The 60° taper is the detail to check first. Before ordering, confirm that the seat matches the wheels you are mounting, because a mismatched seat is the main reason a bolt set will not clamp properly. Buying all ten also keeps the hardware identical at every corner, and the black finish gives a uniform look behind the spokes.
Wheel bolts thread directly into the hub, so the thread engagement and seat contact have to be right before the wheel goes on. Owners on user forums say the wheel can settle during break-in, so re-torque them after traveling the first 50 to 100 miles. The same discussions warn that if you over torque a wheel, you can strip a lug nut, stretch or break a wheel stud, and cause the wheel, brake rotor and/or brake drum to distort. Search terms this set matches include H&R M14x1.5 60 degree tapered wheel bolt set of 10, 45mm tapered lug bolts for aftermarket wheels, and black 17mm hex wheel bolts.
The manufacturer lists this as a set with a quantity of 10 bolts. The single-piece version, 1454501SW, is listed separately.
Owners on user forums recommend re-checking torque after the first 50 to 100 miles on new wheels, since the wheel can settle slightly during break-in.
The manufacturer lists a tapered 60° seat. Confirm that this matches the seat on your wheels before ordering.
Replacing lug nuts with bolts is a manageable job for a home mechanic with a 17mm socket and a calibrated torque wrench. Lift the car, remove the wheel, and clean the hub threads and wheel seats before fitting the new bolts. Start each bolt by hand and tighten in a star pattern until the wheel sits flush. Then torque to the value in your vehicle's owner's manual or the wheel maker's instructions, and recheck after the first 50 to 100 miles. The torque value for this specific bolt was not confirmed in research, so do not rely on a number from this page.