The H&R 1454303SW SET is a ten-piece pack of black M14 x 1.5 wheel bolts with a 43 mm threaded length, a VW/Audi ball seat (R13), and a 17 mm hex head. The manufacturer lists it as a set-of-10 part, so one order covers a full wheel set. Its extended shank is built for wheel spacer installations, where the added spacer thickness leaves less of the stock bolt to reach the hub. Enthusiasts searching for extended R13 ball seat lug bolts, 43mm wheel bolts for VW or Audi spacers, or black 17mm hex M14x1.5 lug bolts will find this exact part.
Stock hardware is only long enough for an unspaced wheel, so a spacer setup needs longer bolts to keep proper thread engagement. Owners on user forums report that an 8mm spacer on OEM wheels was run with 14x1.5 35mm R13 ball seat bolts, which shows why the length has to match the spacer you choose. The bigger risk is the cheaper alternative: owners on user forums warn that cone-seat bolts should not be substituted on OEM ball-seat wheels, because the seat can be damaged and the lugs may stop holding torque. Matching the seat type is what makes this set worth the price.
This set uses a VW/Audi ball seat, which the manufacturer lists as R13. Owners on user forums advise against substituting cone-seat bolts on wheels designed for ball seats, since the seat can be damaged.
The correct length depends on your spacer thickness and your stock bolt length, so it has to be checked for each setup. Owners on user forums have reported running 35 mm R13 ball seat bolts with 8 mm spacers on OEM wheels, so confirm the fit for your own spacer before ordering.
This is a straightforward bolt-on job that needs a 17 mm hex socket, a torque wrench, and a clean mounting surface. Owners on user forums recommend removing rust and debris from the hub and spacer contact faces before installing, and tightening in a crisscross pattern. Torque to your vehicle's factory wheel specification from the owner's manual rather than a generic number, since the correct value depends on the car. Use a torque wrench instead of an impact tool to avoid over-tightening. Check that the bolt length works with your spacer before you install the wheels, and re-check torque after the first few dozen miles.