The H&R 1454002SW is a ten-piece set of M14 x 1.5 wheel bolts with a 40 mm shank, a black finish, and a 17 mm hex head. H&R's own catalog lists this part as 14 x 1.5, 40mm, Mercedes Ball, 17mm, with an R14 seat. Its ball seat is the main reason to choose it. Forum members note that ball (or round) seats with R14 radius are required for all OEM wheels and some aftermarket replica wheels, while tapered seats suit most aftermarket wheels. Buying the wrong seat is a safety problem, so a cheap generic bolt is a poor value if the seat does not match your wheels. The 40 mm length suits a spacer setup where the stock bolt would not reach full thread engagement. H&R's spacer documentation says the spacer mounts between wheel and hub on longer bolts that are not included.
Owners on user forums say that a longer bolt is needed for every millimeter of spacer thickness, so confirm your required length before ordering a set. For installation, start each bolt by hand so the threads do not cross, then tighten in a star pattern with a torque wrench set to your vehicle's wheel torque specification. Owners recommend re-torquing after the first 50 to 100 miles. Search terms this set targets include M14x1.5 ball seat lug bolts, 40mm R14 wheel bolts, Mercedes spacer lug bolts, and black 17mm hex wheel bolts.
No. The manufacturer identifies this bolt by thread, length, seat type, and head size rather than by vehicle. Confirm that your wheel uses an R14 ball seat and that your hub accepts M14 x 1.5 threads before ordering.
Possibly. The manufacturer states that its wheel spacers are mounted with longer wheel bolts, which are sold separately. Choose a length that matches your spacer thickness, and confirm the thread engagement before driving.
Owners on user forums report that ball-seat bolts are not interchangeable with tapered-seat wheels. Check your wheel's seat type before installing a set.
This is a moderate DIY job that requires a 17 mm socket, a calibrated torque wrench, and a clean hub face. Remove the wheel, clean the hub and mating surfaces, and check that the bolt seat matches your wheel. Thread each bolt by hand to avoid cross-threading, then tighten in a star pattern to your vehicle manufacturer's specification. Owners on user forums recommend re-torquing after the first 50 to 100 miles. If you are running spacers, verify that the new bolts engage the hub fully before lowering the vehicle.