These H&R wheel bolts are M14 x 1.5 fasteners with a 38 mm shank, a 60° conical (tapered) seat, and a 17 mm hex head. The manufacturer's configurator lists article 1453801 as a silver 60° taper-head bolt with M14x1,5 thread, 38 mm shaft length and 17 mm spanner size. The set version is a separate article number. Because the taper must match the wheel's seat exactly, a 38 mm cone-seat bolt is a practical upgrade when you need extra thread reach. It is a common choice when a wheel spacer requires longer hardware than the factory bolts provide, and the set format lets you replace all lugs in one purchase. Stock bolts that are worn, mismatched, or too short can compromise clamping, so buying correct-spec hardware is a safety decision, not just a cosmetic one. Search terms: M14x1.5 38mm tapered lug bolt, 60 degree cone seat wheel bolt 17mm hex, H&R wheel spacer bolts, H&R 1453801 set.
For installation, confirm your wheel uses a 60° cone seat before ordering, since a ball-seat wheel needs a different bolt. Clean the hub and seat surfaces, start each bolt by hand to avoid cross-threading, and tighten in a star pattern with a calibrated torque wrench to your vehicle manufacturer's published wheel-bolt specification. Avoid impact guns, which can damage threads and the seat. Check thread engagement and brake or ABS clearance when using extended lengths with a spacer. Re-check torque after the first few hundred miles of driving.
Yes. The manufacturer lists the black finish under a separate article number, B1453801, with the same M14 x 1.5 thread, 38 mm length, 60° seat and 17 mm hex.
Details vary. The manufacturer's configurator describes the SET article as a wheel-lock set that includes a wheel lock, which is different from a plain set of bolts. Confirm the exact contents with the manufacturer before ordering.
Torque the bolts to your vehicle manufacturer's published wheel-bolt specification, using a torque wrench in a star pattern. The bolt itself does not set the torque value.
This is a straightforward job with a jack, stands, a 17 mm socket or wrench, and a calibrated torque wrench. Lift and support the vehicle safely, remove the wheel, and swap the bolts one at a time to keep the wheel supported. Hand-thread each new bolt until it seats, then tighten in a star pattern to the specified torque. Common gotchas include cross-threading, using an impact gun, and assuming a bolt fits a ball-seat wheel. If you are using a spacer, verify clearance to brake components and re-check torque after initial driving.