The H&R 1454001SW SET is a 10-piece pack of black M14 x 1.5 wheel bolts with a 40 mm shank, a 60-degree tapered seat, and a 17 mm hex head. The manufacturer lists these as the replacements for factory wheel fasteners, and as the longer hardware that H&R spacer kits require. Matching the stock seat geometry and thread pitch is what keeps the wheel seated correctly. Cheap mismatched bolts can seat poorly or lose engagement. The manufacturer's guidance also sets a minimum of 7.5 turns of thread engagement, about 12 mm, for this thread size. Shorter engagement is a real safety concern under track or hard-driving loads. This set is a good fit for owners running wheel spacers who want OEM-style bolts in a black finish. Common search terms include M14x1.5 60 degree tapered lug bolts, extended wheel bolts for spacers, and conical seat 40mm lug bolts black.
Before ordering, check that your existing bolts have the same head style, since the manufacturer requires the new head to match the one currently installed. Installation is a moderate DIY job that needs a 17 mm socket and a calibrated torque wrench. Hand-start each bolt so it spins in freely and avoids cross-threading, snug them in a star pattern, then torque them in stages to your vehicle or wheel manufacturer's specification. Owners on user forums recommend re-checking torque after the first 100 miles, and running the wheel by hand afterward to confirm clearance against brake and ABS components.
The manufacturer states the new bolt head must be identical to the one already installed. This set uses a 60-degree tapered seat. Ball-seat or round-head wheels require different part numbers, so confirm your existing seat type before ordering.
The manufacturer specifies that replacement bolts must be longer than the original bolts by the width of the spacer being used. Engagement must still reach at least 7.5 turns of thread, so check the bolt does not bottom out in the hub.
Owners on user forums recommend re-checking torque after the first 100 miles of driving, since wheel and spacer seating can settle during initial use.
Difficulty is moderate and mostly about getting the torque right. Use a 17 mm socket and a calibrated torque wrench, and clean the hub and mating surfaces before mounting. The manufacturer's install guidance for spacer systems calls for turning each bolt by hand to confirm it spins freely before tightening, and for tightening in a star pattern with a torque wrench set to the wheel manufacturer's specification. Confirm the bolt does not contact any brake or ABS components before driving, and re-torque after the first 100 miles.