This H&R 14 x 1.5 wheel bolt is the black, 30mm-thread version of the manufacturer's tapered-seat lineup, sold as a box of ten for two wheels on a five-lug hub. The manufacturer's catalog lists a 60° taper seat with a 17mm hex head, and H&R's own table pairs this black SET number with the 1453001 silver option. Buyers searching for 14x1.5 60 degree conical seat lug bolts, black 17mm hex, or 1453001SW set of 10 are looking at the right listing. Compared with a bolt that merely reaches the hub, a purpose-built extended bolt is what keeps the thread engagement correct once spacers or wider wheel setups are in play. The manufacturer's application notes say replacement bolts must be longer than the original by the thickness of the spacer used, and the head style must match the existing bolt.
Before ordering, confirm your wheel's seat type and lug thread, because the manufacturer specifies a tapered 60° seat and a 14x1.5 thread, not a ball seat. The 30mm thread length is a short extended length, so measure your spacer and original bolt length before deciding whether it covers your setup. Owners on user forums who ran spacers with bolts that were too short report torque loss and loosening, and they generally advise sorting out bolt length rather than simply raising torque. Owners also describe swapping stock bolts for longer H&R bolts as the normal route when fitting spacers. Treat any vehicle-specific fitment claim as something to verify against your spacer's documentation.
The manufacturer's catalog lists the black version as a SET with a quantity of 10 per box, so the set covers both wheels on a five-lug hub.
The manufacturer lists this bolt with a 60° tapered seat. Check your wheel's seat design before ordering, since H&R's ball-seat bolts are a separate part.
The manufacturer states that its DR series spacers require longer wheel bolts ordered separately, and its application notes say new bolts must be longer than the originals by the spacer's width. Confirm the spacer thickness against this 30mm length before installation.
Swapping these bolts is a basic job: you need a 17mm socket and a calibrated torque wrench, plus a way to lift the vehicle safely. Remove the wheel, and if you are adding spacers, seat the spacer flush against the hub before mounting the wheel, as owners on user forums recommend. Hand-thread each bolt to avoid cross-threading, then torque to your vehicle's factory wheel specification in a star pattern, and recheck after the first few drives. Torque specs are vehicle-specific, so confirm the value in your owner's manual or service documentation.