The H&R 1452802SW SET is a 10-bolt box of M14x1.5 wheel bolts with a 28mm threaded length, an R14 Mercedes-style ball seat, and a 17mm hex head. The manufacturer's catalog lists the black version as a 10-piece box with a 17mm head, which is the sku this listing covers. Buyers searching for a 14x1.5 ball seat wheel bolt for Mercedes wheels, a 28mm black lug bolt set, or an R14 replacement bolt kit should find the exact match here.
Seat geometry matters more than most shoppers expect. Owners on user forums who measured their wheel seats found that an ill-matched bolt contacts only the outer edge, which can damage the wheel over time. A correct R14 ball seat avoids that problem. Buying a matched set of ten also means you can replace an entire wheel's hardware in one step instead of mixing parts from different sources, and the black finish gives the wheel-side hardware a uniform look.
Before ordering, confirm your wheels use an R14 seat, since owners on user forums say a ball seat in a mismatched wheel will hold the wheel but will not make full contact. One forum suggestion for checking the seat profile is to press silly putty, clay, or medical therapy putty into the wheel bolt hole to get an exact impression. For length, put the original bolt in the original wheel and measure how much thread protrudes. Tighten with a calibrated torque wrench in a star pattern to the vehicle or wheel maker's specification, and check torque again after the first few miles.
The manufacturer lists the natural 1452802 and the black 1452802SW with the same 14 x 1.5 thread, 28mm length, Mercedes ball seat, and 17mm head. The black version is the one with the SW suffix.
Owners on user forums suggest checking the seat profile with putty pressed into the bolt hole, or confirming the seat radius with the wheel maker before buying a set.
No. Torque values come from the vehicle owner's manual or the wheel manufacturer's instructions, not the bolt itself.
This is a moderate DIY job that needs a 17mm socket, a calibrated torque wrench, and a clean hub face. Clean the wheel seats and hub mating surface before installing the new bolts, and thread each one in by hand to avoid cross-threading. Tighten the bolts by hand in a star or criss-cross pattern until they cannot be turned by hand. Then lower the vehicle and finish with the torque wrench in the same pattern. Avoid using an impact wrench for final torque. Some tire and wheel service guidance recommends rechecking the torque after a short distance. Confirm the bolt length and seat type before you start, since a wrong length or seat can prevent the wheel from seating correctly.