This H&R 14 x 1.25 wheel bolt is a 50mm extended fastener with a 60-degree tapered seat, a 17mm hex head, and a black finish, sold in a set of ten. The manufacturer builds its bolts to match its TRAK+ wheel spacer range, so the main reason to buy these over factory hardware is reach. Stock bolts are usually too short once a spacer sits between hub and wheel, and a short bolt leaves too little thread engaged to hold clamp load safely. Choose these when you need a tapered-seat bolt that is longer than stock and made by the same company as the spacer. Search terms: extended 14x1.25 tapered lug bolts, 50mm wheel spacer bolts, black 17mm hex lug bolts, H&R TRAK+ bolts.
Before ordering, confirm the seat type and length for your wheel. The manufacturer's ordering guidance says to specify the cone type when buying longer bolts for a spacer, so a tapered bolt will not seat in a ball-seat wheel. Owners on user forums who have fitted H&R spacers say the job takes most of its time in cleaning the hub and rim faces, and that re-checking torque after the first 100 miles or so is worthwhile. Hand-thread each bolt so it spins in freely, snug them in a star pattern, then finish with a calibrated torque wrench set to your vehicle or wheel specification. Skip the impact gun.
The manufacturer states that its wheel spacers fit between the wheel and the hub and need longer wheel bolts, which are ordered separately. These 50mm bolts are the extended option in the 14 x 1.25 tapered series for that purpose. Confirm the required length against your spacer thickness before ordering.
Owners on user forums commonly recommend re-tightening H&R spacer bolts with a torque wrench after roughly 100 miles of driving. The manufacturer's installation instructions also call for a torque check after initial driving.
The manufacturer's ordering guidance says to confirm the cone type, since a tapered bolt must match a tapered seat in the wheel. Check your wheel's seat design before purchasing.
Installation is a moderate DIY job that needs a jack and stands, a calibrated torque wrench, and a 17mm socket, ideally thin-walled so it clears the wheel face. Remove the stock bolts, clean the hub and rim contact surfaces, and mount the spacer and wheel. Start each new bolt by hand to avoid cross-threading, snug them in a star pattern, and then torque to your vehicle or wheel specification. Before final torque, spin the wheel to check for rubbing or interference. Re-check torque after the first stretch of driving.