This H&R 14 x 1.25 wheel bolt is a black steel fastener with a 60-degree tapered seat, a 43mm thread length, and a 17mm hex head, sold here as a set of ten (14254301SW SET). The manufacturer's wheel bolt range covers several thread lengths and seat styles, so this 43mm tapered version is meant for applications that need that specific reach and seat. Choose it over a generic hardware-store bolt when the seat angle and length matter, because a mismatched seat can keep a wheel from clamping evenly. Search terms: 14x1.25 tapered lug bolt, 60 degree seat wheel bolt, 43mm black wheel bolt set of 10, H&R wheel spacer bolts.
Buying the full set of ten gives you matching fasteners for one wheel set, which is the practical reason to choose the set over single bolts. Check the 43mm thread length against your hub face and any spacer thickness before ordering, since too little thread engagement is a common cause of problems and a longer bolt can bottom out. Confirm the seat and thread with the manufacturer or your wheel's specifications if your wheels are not a standard 14 x 1.25 tapered design. Use these bolts with a calibrated torque wrench to the value listed in your vehicle or spacer instructions.
The manufacturer lists the single bolt as 14254301SW and the set of ten as 14254301SW SET. This listing is the ten-piece set.
The manufacturer specifies a 60-degree tapered seat for this bolt, so it is not a ball-seat or Mercedes-style bolt.
The manufacturer specifies a 17mm wrench size for this bolt.
Installation is a straightforward bolt-on job with basic hand tools. You will need a 17mm socket or wrench, a torque wrench, and ideally a breaker bar for breaking them loose. Start by confirming the 43mm thread length and 60-degree seat work with your hub and any spacer you are running. Keep the threads clean and dry, start each bolt by hand to avoid cross-threading, and tighten them in a criss-cross sequence. Finish with a torque wrench rather than an impact gun, and recheck torque after the first 50 to 100 miles of driving.