The H&R 1453501SW set packages ten black M14 x 1.5 wheel bolts, each 35 mm long with a 60° tapered (cone) seat and a 17 mm hex head. The manufacturer's catalog lists this exact configuration as a set of ten, and the same thread and seat family runs in lengths up to 60 mm, so a builder can stay within one product line when a specific length is needed. A 60° cone seat draws the wheel onto the hub and self-centers it as the bolt is torqued, so a matched set keeps thread pitch, seat angle, and head size consistent at all four corners.
Before ordering, confirm your wheels use a cone seat, because a ball-seat wheel will not accept this bolt. Check the back of the wheel's bolt hole: a straight 60° recess means a conical seat. If you are running spacers, the manufacturer's spacer documentation sets the bolt length and thread reach you need, so verify that before fitting. Searches for 14x1.5 tapered wheel bolts, 60 degree cone seat lug bolts, and 35mm black wheel bolts with a 17mm head will point you to this exact part number.
The manufacturer advises checking the wheel tightening torque after about 100 km of driving and retightening with a torque wrench if needed.
The manufacturer states that spacer systems require longer wheel bolts ordered separately, and that the bolt's minimum thread reach must be verified against the spacer documentation before installation.
Inspect the wheel's bolt hole. A straight tapered recess at 60° indicates a conical seat, while a curved, spherical recess indicates a ball seat. If you are unsure, confirm with the manufacturer before ordering.
This is a basic-to-intermediate job for a home mechanic. You will need a 17 mm socket or hex bit, a torque wrench, and the vehicle's torque specification, which is usually listed in the owner's manual. Start each bolt by hand so it does not cross-thread, then snug all of them and tighten in a star pattern to the final torque. Recheck torque after roughly 100 km. If you are installing spacers, rotate the wheels by hand after assembly to confirm the longer bolts do not contact ABS sensors or brake components.