H&R's 14254001SW set packages ten black wheel bolts with an M14x1.25 thread, a 40mm thread length, a 60-degree tapered seat, and a 17mm hex head. The manufacturer lists this size within its wheel bolt range, which covers several thread pitches, lengths, and seat types. Choose the 40mm length when a wheel spacer adds thickness between the wheel and hub, because a shorter stock bolt may not reach full thread engagement. The tapered seat must match the seat in your wheel's bolt holes, so confirm that before ordering. Buying ten pieces also covers a full wheel set with a spare, rather than buying singles one at a time. Keywords: 14x1.25 tapered lug bolts 40mm, black conical seat wheel bolts, extended wheel spacer bolts, H&R 14254001SW set of 10.
Check the spacer before you choose this length. The manufacturer states that H&R wheel bolt thread length must always match the thickness of the wheel spacer, so measure the spacer rather than assuming 40mm fits. If your vehicle's original bolts use a moving tapered or spherical collar, the manufacturer advises using bolts of equal length that also have a moving collar. Installation is a standard bolt-on job: hand-thread each bolt to avoid cross-threading, snug them in a star pattern, then torque to the wheel manufacturer's specification with a torque wrench. Verify your hub thread pitch and seat type before purchase.
The manufacturer states that the thread length of its wheel bolts must always match the thickness of the wheel spacer. A 40mm bolt therefore suits only a spacer of matching thickness, so confirm the spacer dimension before fitting.
Details vary across sources on whether lock bolts are included with this exact set. Confirm with the manufacturer before ordering if locks are important to you.
The manufacturer directs installers to tighten the bolts in a star pattern to the wheel manufacturer's torque specification. Use your wheel maker's published value rather than a figure from another source.
This is a straightforward bolt-on job that needs a socket set, a torque wrench, and a way to lift and support the vehicle safely. Remove the wheel, compare each new bolt against the original for length and seat type, and hand-thread every bolt first so the threads do not cross. If you are fitting a spacer, the bolt length must match the spacer thickness, and any original bolts with a moving collar need a matching replacement. Snug the bolts in a star pattern, then torque to the wheel manufacturer's specification. Re-check torque after the first drives, as the manufacturer's spacer guidance calls for re-tightening the bolts.