The H&R 14253501SW SET is a ten-piece pack of black wheel bolts in 14 x 1.25 thread, with a 35mm thread length, a Tapered (60º) seat, and a 17mm head. H&R lists this as a 14 x 1.25 · 35mm · Tapered (60º) · 17mm · Black, Qty. 10 set. Its sibling 1453501 uses a 14 x 1.5 pitch under a separate part number, so check the pitch of your existing bolts before ordering. Pitch is the detail most likely to cause a mismatch on a 14 x 1.25 application.
Stock bolts usually cannot reach through a wheel spacer, which is where this set earns its price. H&R's application notes state that All DR-Systems require longer wheel bolts, and that replacements must run longer than the originals by the width of the spacer used. The same notes give M14 x 1.25 = 9.0 turns = approx. 12 mm of load bearing shaft length, so a bolt that is too short is a safety problem rather than a cosmetic one. Buying a matched ten-piece set keeps all hub fasteners identical.
The manufacturer states that DR-series spacers require longer wheel bolts than stock. Its application notes also say the new bolts should be longer than the originals by the spacer's width.
The manufacturer's application notes give 9.0 turns, or approximately 12 mm of load-bearing shaft length, as the engagement figure for M14 x 1.25 bolts.
No. The manufacturer lists the 14 x 1.25 and 14 x 1.5 bolts under separate part numbers, so confirm the thread pitch of your existing bolts before ordering.
This is a moderate DIY job that mainly rewards care. Hand-start each bolt so it spins freely, which helps avoid cross-threading, and check that the wheel turns freely with the spacer installed. Make sure the bolts do not contact any part of the brake system, including ABS sensors. Snug the bolts in a star pattern with a calibrated torque wrench, then torque them to the vehicle or wheel manufacturer's specification. Owners on user forums recommend re-checking torque after the first 50 to 100 miles, since new wheels can settle slightly.