The H&R 1453001SW is a black 14 x 1.5 wheel bolt with a 30 mm shank and a 60-degree tapered seat, built to clamp a wheel through a 17 mm hex head. Its 60-degree cone seat is the detail that matters most when choosing a replacement or spacer bolt, because the seat has to match the wheel. H&R's own guidance says its wheel fasteners come in taper, flat and round heads, so matching the seat is essential before ordering.
Buyers usually pick this bolt when a wheel spacer needs a longer fastener or when a worn factory bolt needs replacing with a black, correctly seated one. The manufacturer states that a replacement screw's head must be identical to the installed one, so a cone-seat bolt is the right choice for a cone-seat wheel and the wrong one for a ball-seat wheel. Spacer kits also often need longer bolts that are ordered separately, with the cone type and extra length specified, which makes this 30 mm length a useful companion for spacer builds.
Owners on user forums recommend tightening in a crisscross sequence with a calibrated torque wrench, then re-torquing after the first 50 to 100 miles, since new wheels and spacers can settle. Keep a 17 mm socket and a torque wrench ready, and avoid impact guns. Searches like "14x1.5 60 degree taper wheel bolt 30mm black," "M14x1.5 cone seat lug bolt," and "wheel spacer extended bolt 30mm" match this part.
No. The manufacturer's guidance is that the replacement head must match the original wheel screw design, and this bolt uses a 60-degree cone seat. Confirm your wheel's seat type before ordering.
The manufacturer says that several of its spacer systems mount the spacer using longer bolts that are not included. When ordering, specify the cone type and the extra length you need.
Owners on user forums commonly re-torque after the first 50 to 100 miles, particularly after fitting new spacers or wheels, because the clamping load can settle during initial driving.
Installation is a straightforward bolt-and-torque job for anyone comfortable with a torque wrench, but it is not a quick swap. Remove the wheel, confirm the seat type matches the wheel, and thread the bolt in by hand before tightening. Work in a crisscross pattern in at least two passes, finishing with a calibrated torque wrench set to your vehicle manufacturer's wheel-bolt specification. Because the bolt length must engage the hub correctly without bottoming out, check clearance against brake and ABS components behind the hub, especially on spacer setups. Schedule a re-torque after the first short drive.