The Dinan D220-0005 is a set of ten 40mm lug bolts with an M14x1.25 thread and an OEM-style cone seat, made for running wheel spacers. The manufacturer describes them as longer than factory bolts, so they can reach through spacer thickness and still engage the hub. They are steel with a black finish, and Dinan lists them among its wheel bolts for BMW, Mercedes-Benz and Toyota performance builds.
Stock-length bolts will not reach through a spacer, so a longer replacement is required once you add one. Matching Dinan's cone seat to the wheel's seat keeps the wheel centered the way it was designed to be, and the manufacturer's application chart ties the thread pitch to the chassis, which helps you avoid a costly M12x1.5 versus M14x1.25 mix-up. Buyers searching for extended wheel spacer bolts, M14x1.25 cone seat lug bolts, 40mm spacer studs, or 5x112 G-chassis spacer hardware will find the exact fitment details below. The manufacturer's chart lists E-chassis 5x120 cars on M12x1.5, F-chassis 5x120 on M14x1.25, and G-chassis 5x112 on M14x1.25, with listed exceptions such as certain F9x M5/M8 and F48/F39 X1/X2 models that use the G-chassis spacer fitment. Installation is a wheel-off job, so plan for a torque wrench, jack stands, and spacer-specific instructions.
The manufacturer's general spacer and bolt application guide assigns M14x1.25 to F and G chassis vehicles and M12x1.5 to E chassis vehicles. The guide notes that exceptions exist, so confirm your specific model is listed before ordering.
The manufacturer describes this bolt as longer than factory and intended for use with wheel spacers. For a non-spacer installation, confirm the correct length with the manufacturer before ordering.
The manufacturer sells this part as a set of 10 lug bolts in a 40mm length with a cone seat.
Installation requires removing the wheel, so this is a moderate DIY job for someone comfortable with jack stands and a torque wrench. Before you start, confirm the thread pitch matches your chassis using the manufacturer's application guide, and check that the cone seat matches your wheel. Thread each new bolt in by hand first; if it binds, stop and recheck the thread size rather than forcing it. Avoid using an impact wrench for final tightening, and do not apply lubricant to the threads or seats unless your spacer or wheel instructions call for it. Torque values were not confirmed for this part during research, so follow the torque specification from your spacer and wheel documentation and re-check torque after the first few drives.