The BAK Revolver X4s Hard Roll-Up Tonneau Cover (80223) is made for the 2019-2026 Ram 1500 with a 6'4" bed. It is a hard roll-up, so the bed opens by rolling the cover toward the cab instead of folding panels.
The Revolver X4s is BAK's most secure do-it-all hard roll-up, with Level-3 slash resistance, a seamless matte vinyl surface and a low profile.
Ram owners tend to work the bed hard, and a cover that protects the load without limiting what you can haul does the job.
Roll it back and the whole bed is yours. Safety straps secure the rolled cover, and it stays clear of the rear window and factory cameras while you drive. There are no panels to prop up or stow.
Matte TriShield vinyl over a slat core. The 70-grade vinyl rides on interlocking aluminum slats that carry up to 400 lb evenly distributed, and the 360-degree matte black aluminum finish carries through the slats, clamps and hardware.
Sealed where it counts. Side seals fit flush against the cover and an integrated bulkhead seal closes off the front, while the nearly flush fit with the rails keeps the profile clean.
A roll-up built to resist break-ins. Interlocking aluminum slats, rotational locking rails and automatic slam latches give it a Level-3 security rating and real slash resistance.
The BAK 80223 gives you locking, slash-resistant coverage when the bed is closed and a clear bed when it is rolled up, backed by a five-year limited warranty. Get it from Track Ready Products.
Expect to be done in under an hour. The Revolver clamps to the bed rails with the included kit, so there is no drilling.
Start with a clean set of rails. Position the cover, tighten the clamps evenly, and run it through a full open and close cycle to check that it moves freely and latches.
After the first week of driving, recheck the clamps and retention hardware for tightness, and check them again now and then. Wash with mild automotive soap and water, keep the cover secured at all points while driving, and clear snow and ice before opening.
