If you drive a 1993-2011 Ford Ranger with a 6' bed, the BAKFlip G2 Hard Folding Tonneau Cover 226305 is a cover to look at. The hard panels protect your cargo from weather and prying eyes, and the folding design opens the bed in one move.
The BAKFlip G2 combines aluminum-skinned panels, EPDM perimeter seals and automatic slam latches in a cover that clamps on without drilling.
Ranger owners tend to use the bed for gear and projects alike, and a lockable cover keeps the load protected between trips.
Full bed access without removing the cover. The panels fold forward against the cab, so you can drive with the bed open for tall or bulky cargo while the cover stays secured on the truck. Fold it back down and the bed is covered again in seconds.
It locks as you close it. BAK's patented rail and clamp system uses automatic slam latches, so each panel locks when it shuts. Close the tailgate, press the cover down, and your gear is out of sight and locked in.
A sealed perimeter with somewhere for water to go. The EPDM seals hug the bed rails, and the drainage system gives rain and runoff a path that does not run through your cargo area.
Aluminum over a solid core. That construction keeps the cover light enough to live with and tough enough for the job, and the semi-gloss black powder coat is made to resist fading and chipping. Struts hold it against the cab when folded to keep the ride quiet, and you can carry up to 300 lb of evenly distributed weight on top.
Assembled in the USA and backed by BAK's three-year limited warranty, the G2 is a straightforward way to put a hard, lockable lid on your truck. Order the BAK 226305 from Track Ready Products, and match the bed length shown above before you check out.
No drilling and no cutting. The cover clamps to the bed rails and the kit and hardware ship in the box, so with basic hand tools most installs take about 30 minutes or less.
Clean the bed rail caps first so the seals sit on a clean surface, set the cover in place, and tighten the clamps evenly from side to side. Work the cover open and closed once before you load the bed.
Care is simple: mild automotive soap and water for cleaning, a clamp check after about a week and periodically afterward, the cover secured whenever the truck is moving, and snow and ice cleared before you open it.
