Give the 2024-2025 Ford Ranger and Ranger Raptor with a 5'1" bed a lockable hard cover with the BAK BAKFlip MX4 448342. The hard panels protect your cargo from weather and prying eyes, and the folding design opens the bed in one move.
As a Gen 3 BAKFlip MX4, this cover raises the load rating to 400 lb and improves the seals and latching.
A mid-size bed fills up fast. A hard cover that secures the load and still opens up for the big stuff makes the Ranger more capable day to day.
Sealed against the weather. Revised EPDM rubber perimeter seals and tight-fit clamps close the gap between the cover and the bed rails, and the dual-action tailgate seal, available on most applications, is 13% longer than before. An integrated drainage system carries water away.
Textured matte black, flush to the rails. The finish carries across every component, and the cover sits flush with the bed rails, so it looks right whether it is open or closed.
Open the bed, keep the cover. Drop the tailgate, release the rear latch, and fold the cover up against the cab for 100% bed access, even for large cargo. Re-engineered prop rod clips hold it open, premium rubber bumpers protect the cab and the cover, and the third brake light stays visible in every position.
It locks itself. Close the cover and the latch engages. Gen 3 uses redesigned latching panels and lock hardware that BAK built to resist forced entry better than the Gen 2 design.
Gen 3 strength. The top panels are multi-layer aluminum over a high-density polymer core and are 22% stronger than the original MX4, while precision-engineered aluminum side rails and frame keep the cover rigid. It is rated for 400 lb of evenly distributed weight.
For a folding cover that locks itself, seals tight and fits flush, the BAK 448342 is a strong choice. It is assembled in the USA, backed by a five-year limited warranty, and available from Track Ready Products.
The Gen 3 click-in mounting makes this a one-person job, typically 30 minutes or less, with no cutting, trimming or drilling on most trucks. Clamps and hardware are included.
Wipe down the rails, seat the cover, then snug the clamps a little at a time on both sides so it pulls down square. Test the latch and the open and close action while the bed is still empty.
Recheck the clamps after about a week, wash with mild automotive soap and water, and clear off snow and ice before opening. Keep the cover secured at all points whenever you drive.
