The BAKFlip G2 Hard Folding Tonneau Cover (226446) is made for the 2024-2026 Toyota Tacoma with a 5' bed. It folds forward against the cab for full bed access, then closes and locks to protect what you carry.
The BAKFlip G2 combines aluminum-skinned panels, EPDM perimeter seals and automatic slam latches in a cover that clamps on without drilling.
A Tacoma bed is built for gear. Covering it keeps that gear locked up and out of the weather without giving up access when you need it.
Strength without the weight. Aircraft-grade aluminum skins over a solid core give the panels their rigidity, and the semi-gloss black powder coat stands up to fading and chipping. The low-profile fit looks clean on the truck, built-in struts keep the folded cover from rattling against the cab, and the load rating is 300 lb evenly distributed.
Built to shed water. Precision-fit EPDM rubber seals run the perimeter, the hinges are rounded, and an integrated drainage system sends water away from the bed, which helps keep rain and wash-down spray outside.
Full bed access without removing the cover. The panels fold forward against the cab, so you can drive with the bed open for tall or bulky cargo while the cover stays secured on the truck. Fold it back down and the bed is covered again in seconds.
Hard panels, and a latch that does the work. The rail and clamp system locks each panel automatically when you close it, so locking up never gets skipped.
Before you order: It requires the Toyota Deck Rail System. Also match the bed length shown in the fitment line above.
The BAK 226446 pairs a hard, lockable lid with a clamp-on install that most owners handle themselves. It is assembled in the USA, covered by a three-year limited warranty, and available now from Track Ready Products.
This is a clamp-on install: no drilling, hardware included, and a typical time of 30 minutes or less with hand tools.
Start with a clean set of rails. Position the cover, tighten the clamps evenly, and run it through a full open and close cycle to check that it moves freely and latches.
Recheck the clamps after about a week, wash with mild automotive soap and water, and clear off snow and ice before opening. Keep the cover secured at all points whenever you drive.
