H&R's 70824 is a 28mm two-hole adjustable front anti-roll bar for the E36 3 Series, built from 50CrV4 alloy spring steel. Each bar is shot peened and heat treated, with precision forged ends, and many applications offer multiple end link mounting points for adjustability. Compared with the stock front bar, the larger diameter resists body roll and weight transfer through corners, which is the upgrade a buyer is paying for. The bar is sold as a single front piece, so it suits drivers who want sharper front-end response without changing the rear bar or the springs. Searches for "E36 325i 28mm front sway bar," "318is adjustable sway bar," and "E36 coilover front anti-roll bar" describe the buyers this part targets.
Fitment is the most important check before ordering. The title covers 1992–1998 318i, 318is, 325i, 325is, 328i and 328is cars, but application details vary between sources on which years and engines are covered, so confirm your exact chassis and engine with the manufacturer or a VIN lookup. Owners on user forums note that front bar mounting points matter as much as diameter, and that non-M E36 front bars attach to the lower control arm, which gives them less leverage than M3-style mounts. If you have swapped in E46 control arms, owners on user forums report tire and frame-rail contact with the front bar, so check clearance at full lock. The bushings are urethane/Teflon composite, and the product description says they need no grease, although installers should confirm lubrication guidance with the manufacturer.
Owners on user forums report that tires and frame rails contacted the front bar after E46 control arms were fitted to an E36, and some removed the bar to clear it. Check clearance at full steering lock after installation.
Owners on user forums differ on this. Some say a stiffer front suspension lets a driver run without a front anti-roll bar, while others find the bar improves stability in drift and high-speed corners. Fitting it and comparing the feel is the most common approach.
This is a bolt-in replacement that uses the factory mounting points, so it is a moderate-difficulty job for a home mechanic with a jack, jack stands, and a socket set. Support the car on stands rated for its weight, remove the stock bar and end links, and clean the bar before fitting new bushings. Owners on user forums recommend fitting the bushing brackets before the end links, expect the bar to need some shimming to seat, and tighten the end link bolts while the bar is still out of the car. Owners on user forums also recommend threadlocker on the bolts, since loose hardware is a common complaint after sway bar upgrades. Tighten all fasteners with the car at ride height, and recheck torque and clearance after the first few drives.