The H&R 71910 is a 24mm rear sway bar for the BMW E36 M3, built as an adjustable two-hole design. H&R's sport bars use forged ends so you can change stiffness by moving the end link between two positions, which makes this a practical step up from factory hardware for drivers who want less body roll without a harsher ride. A larger-diameter rear bar resists roll more and helps the rear end rotate on turn-in, which matters on track days, autocross, and aggressive back roads. Compared with a cheap generic bar, the H&R's spring-steel construction and German manufacturing are the reasons to pay for a name-brand part.
Fitment is the main thing to verify before you buy. Sources disagree on the production years this bar covers, with some listing 1994 to 1996, others 1995 to 1999, and some including the cabrio. Confirm the application with the manufacturer against your car's build date before ordering. Owners on user forums report that aftermarket rear bars can contact the lower control arm once the car is lowered or fitted with coilovers, so check clearance at ride height. Searches for E36 M3 rear sway bar 24mm adjustable, E36 M3 2 hole rear anti-roll bar, and H&R 71910 install should lead you to this exact part.
Sources list different year ranges, including 1994 to 1996 and 1995 to 1999, and some include cabrio models. Confirm fitment with the manufacturer using your car's build date before ordering.
Owners on user forums report that aftermarket rear bars can contact the lower control arm once the car sits lower. Check clearance with the car back on the ground, not just on jack stands, and confirm the setup with the manufacturer if contact persists.
This is a moderate-difficulty job that requires a safely supported car, a socket set, and a helper for handling the bar. Remove the stock rear bar and its end links, fit the new bar with the stock mounting points, and tighten the hardware only after the bar sits where it should. Because the clearance concern is common, set the end link length with the suspension at its normal ride height and recheck clearance to the lower control arm before driving. Replace any worn stock bushings or end links while the bar is out.