The H&R 25mm adjustable front sway bar (part 70839) is a front anti-roll bar for the first-generation Mazda MX-5 Miata, chassis code Typ NA. The manufacturer lists it for 1989–1998 cars, and it replaces the factory front bar. It has two adjustment holes, so you can change its stiffness without buying a second bar, which makes it a practical tuning piece for a street-driven NA or a weekend autocross car.
Owners on user forums say the front bar makes a clearly noticeable difference in body roll compared with stock. A thicker front bar resists roll more and shifts the balance toward understeer, while a stiffer rear bar pushes the car toward oversteer, so the front-to-rear balance is the tuning lever. Owners also point to the Teflon-impregnated bushings, which avoid the regular re-greasing that factory rubber bushings need. This is a better buy than a bargain bar if you want adjustability and a bar sized for real cornering loads, not just a cosmetic swap.
Fitment is the first thing to confirm. The manufacturer's listing covers 1989–1998 Miata NA cars, but some retailer listings show narrower year ranges, so check your model year before ordering. Owners report the front bar is the tighter of the two swaps because of the A/C condenser and subframe clearance, and that a helper and a careful route through the engine bay make the job much easier.
The manufacturer lists this bar for 1989–1998 Mazda Miata MX-5 Typ NA cars. Some listings show a narrower range, such as 1990–1997, so confirm your model year with the manufacturer before ordering.
Owners on user forums report that the Teflon-impregnated bushings do not need regular re-greasing, unlike factory rubber bushings.
Owners on user forums report that the stiffer inner hole does not suit every NA setup, and that usable holes can depend on engine size and chassis details. Confirm hole selection with the manufacturer for your car.
Plan on a full afternoon for the front bar, and expect the job to be harder than the rear. Owners on user forums report that the factory front bar is tight to remove on cars with A/C and power steering, and that the new bar is often easier to feed through from the passenger side. Safely lift the front of the car onto jack stands, remove the front wheels for clearance, and support the bar and endlinks while you work. Watch the A/C condenser and any nearby hoses or wiring, and recheck clearance once the bar is seated.