The H&R 71839 is an 18 mm adjustable rear anti-roll bar for the first-generation Mazda MX-5 Miata (Typ NA). Its forged ends have three mounting positions, so you can change rear roll stiffness without swapping bars. The manufacturer says its H&R'sport bars add roll stiffness and cornering control without lowering the car or hurting ride comfort. That makes this a targeted upgrade over the factory bar for NA Miata owners who want to tune rear roll resistance while keeping their existing ride height, especially after changing front hardware or springs.
The manufacturer lists this rear bar for the Typ NA chassis from 1989 to 1998, but details vary across sources for some submodels, so confirm your model year with the manufacturer before ordering. Owners on user forums describe the swap as a manageable driveway job using a jack, jack stands, and a 14 mm ratchet, and they recommend soaking the endlink nuts in penetrating oil the day before. If the car has been lowered, forum posters often suggest adjustable endlinks to remove sway-bar preload.
The manufacturer lists this 18 mm adjustable rear bar for the Miata Typ NA from 1989 to 1998. Details vary across sources for some submodels, so confirm your exact year and trim with the manufacturer before buying.
Owners on user forums say adjustable endlinks are most useful on lowered cars, where they help eliminate sway-bar preload. A stock-height car may not need them.
Owner install write-ups on user forums describe this type of rear bar swap as a manageable job for a first-timer working slowly, typically under an hour. You will need a jack, jack stands, and 14 mm ratchet and wrench tools. Spray the endlink nuts and bracket bolts with penetrating oil the day before. The bar ends are angled, so orient the inward-angled end toward the endlink the same way the factory bar sat. Keep the old brackets and bushings aside until you confirm the new bar's hardware matches.